[lkml]   [2001]   [Jul]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    SubjectRe: Is Swapping on software RAID1 possible in linux 2.4 ?
    Nick DeClario wrote:
    > Just out of curiousity what are the advantages to having a RAID1 swap
    > partition? Setting the swap priority to 0 (pri=0) in the fstab of all
    > the swap partitions on your system should have the same effect as doing
    > it with RAID but without the overhead, right? RAID1 would also mirror
    > your swap. Why would you want that?
    > Regards,
    > -Nick

    Setting swap priority to 0 is equivalent to RAID0 (striping) not RAID1 (mirroring).

    Mirroring your swap partition is important because if the disk containing
    your swap fails, your system is dead. If you want to keep your system running
    even if one disk fails you need to mirror ALL your active partitions including
    If you only mirror your data partitions, your are only protected against data
    loss in case of a disk crash (assuming you shutdown gracefully before it panics
    while it tries to read/write on a crashed swap partition and leave your data in
    some inconsistent state).

    Joseph Bueno
    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to
    More majordomo info at
    Please read the FAQ at

     \ /
      Last update: 2005-03-22 12:56    [W:0.024 / U:221.368 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site