[lkml]   [2001]   [Jun]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: 2.2.19: eepro100 and cmd_wait issues
David Lang wrote:
> I am useing the D-link 4 port card without running into problems
> (admittidly I have not been stressing it much yet)

I was able to get the D-Link to work in half-duplex (100bt), but
not in auto-negotiate or full-duplex mode. (Packets would pass,
but there would be huge number of carrier and other bad packets.)

I get a similar problem with the ZNYX 4-port, but I can't even
force it to half-duplex, or any other fixed speed (it just won't go).
It kinda autonegotiates something, claiming to be full-duplex, but it
still shows collisions and I can't get through-put above about 10Mbps
bi-directional, and its dropping many packets.

Ben Greear <> <>
President of Candela Technologies Inc
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to
More majordomo info at
Please read the FAQ at

 \ /
  Last update: 2005-03-22 12:55    [W:0.061 / U:0.128 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site