[lkml]   [2001]   [Mar]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: opl3sa2 in 2.4.2 on Toshiba Tecra 8000

> > 2001-03-29 10:02:50.054774500 {kern|info} kernel: ad1848/cs4248 codec
> > driver Copyright (C) by Hannu Savolainen 1993-1996
> > 2001-03-29 10:02:50.070692500 {kern|notice} kernel: opl3sa2: No cards
> > found 2001-03-29 10:02:50.070703500 {kern|notice} kernel: opl3sa2: 0 PnP
> > card(s) found.
> Add 'isapnp=0' to the end of the options in your modules.conf.
> I *believe* this is fixed in a later kernel (2.4.3pre or 2.4.2ac).

If I am doing this, I can't even load the module and I get the following
message in syslog:

2001-03-29 18:13:14.184156500 {kern|err} kernel: opl3sa2: Control I/O port
0x0 not free

What is that "control i/o port"? Is this normally 0x100? What is the module
parameter to specify this io port? The documentation only mentions "io",
"mpu_io" and "mss_io" but I have specified these parameters already:

modprobe opl3sa2 io=0x538 mss_io=0x530 mpu_io=0x330 irq=5 dma=1 dma2=0

Bye, K
[a735 47ec d87b 1f15 c1e9 53d3 aa03 6173 a723 e391]
(Finger to get public key)
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to
More majordomo info at
Please read the FAQ at

 \ /
  Last update: 2005-03-22 13:18    [W:0.083 / U:0.456 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site