lkml.org 
[lkml]   [2001]   [Mar]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
Subjecteepro100 question: why SCBCmd byte is 0x80?

I am trying to get netgear card working on a new (read as potentially buggy
hardware) MIPS board.

The eepro100 driver basically works fine. It is just after a little while
(usually 2 sec to 15 sec) network communication suddenly stops and I start see
error message like "eepro100: wait_for_cmd_done timeout!".

I looked into this, and it appears that the SCBCmd byte in the command word
has value 0x80 instead of the expected 0. I looked at the Intel manual, and
it says nothing about the value being 0x80.

Does anybody have a clue here? I suspect some timing is wrong or a buggy PCI
controller.

Please cc your reply to my email address. Thanks.

Jun
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-03-22 13:29    [W:0.071 / U:0.084 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site