lkml.org 
[lkml]   [2001]   [Feb]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
Subject2.4.1: ide probs, irq timeout, disk hangs
Hi!

I have regularly the following problems with 2.4.1:

kernel: hda: irq timeout: status=0x80 { Busy }
kernel: hdb: DMA disabled
kernel: ide0: reset timed-out, status=0x80
kernel: hda: status timeout: status=0x80 { Busy }
kernel: hda: drive not ready for command
kernel: ide0: reset timed-out, status=0x80
kernel: VFS: Disk change detected on device ide0(3,64)
kernel: hda: status timeout: status=0x80 { Busy }
kernel: end_request: I/O error, dev 03:01 (hda), sector 52572
kernel: hda: drive not ready for command
kernel: hda: status timeout: status=0x80 { Busy }
kernel: hda: drive not ready for command
kernel: ide0: reset timed-out, status=0x80
kernel: hdb: DMA disabled
kernel: hda: status timeout: status=0x80 { Busy }
kernel: hda: drive not ready for command

And the disk is hanging indefinitely, making noises like:
rrrrrt-click-rrrrrrt-click-rrrrrrt-click-.....
Even turning off power doesn't help always, at least I have
to turn of for some time.

I have linux on hde (Promise controller), hda is windows, hdb
is cd, hdc is another small disk, hdd is cdwriter.
The MoBO has chipset ALi 15x3, (Asus P5A-B). I didn't have
this problems up to (at least) 2.4.0-test10.

From /var/log/boot.msg:
<4>ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
<4>PDC20267: IDE controller on PCI bus 00 dev 50
<4>PCI: Found IRQ 12 for device 00:0a.0
<4>PDC20267: chipset revision 2
<4>PDC20267: not 100%% native mode: will probe irqs later
<4>PDC20267: (U)DMA Burst Bit ENABLED Primary PCI Mode Secondary PCI Mode.
<4> ide2: BM-DMA at 0xa800-0xa807, BIOS settings: hde:pio, hdf:pio
<4> ide3: BM-DMA at 0xa808-0xa80f, BIOS settings: hdg:pio, hdh:pio
<4>ALI15X3: IDE controller on PCI bus 00 dev 78
<4>PCI: No IRQ known for interrupt pin A of device 00:0f.0. Please try using pci=biosirq.
<4>ALI15X3: chipset revision 193
<4>ALI15X3: not 100%% native mode: will probe irqs later
<4> ide0: BM-DMA at 0xa000-0xa007, BIOS settings: hda:DMA, hdb:pio
<4> ide1: BM-DMA at 0xa008-0xa00f, BIOS settings: hdc:DMA, hdd:pio
<4>hda: IBM-DTTA-350840, ATA DISK drive
<4>hdb: TOSHIBA DVD-ROM SD-M1402, ATAPI CD/DVD-ROM drive
<4>hdc: IBM-DCAA-33610, ATA DISK drive
<4>hdd: Hewlett-Packard CD-Writer Plus 9100, ATAPI CD/DVD-ROM drive
<4>hde: Maxtor 52049H4, ATA DISK drive
<4>ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
<4>ide1 at 0x170-0x177,0x376 on irq 15
<4>ide2 at 0xd000-0xd007,0xb802 on irq 12
<6>hda: 16514064 sectors (8455 MB) w/467KiB Cache, CHS=1027/255/63, UDMA(33)
<6>hdc: 7056000 sectors (3613 MB) w/96KiB Cache, CHS=7000/16/63, DMA
<6>hde: 40020624 sectors (20491 MB) w/2048KiB Cache, CHS=39703/16/63, UDMA(100)
<4>hdb: ATAPI 40X DVD-ROM drive, 128kB Cache, (U)DMA
<6>Uniform CD-ROM driver Revision: 3.12

PLease send me a Cc: since I am not subscribed! Tell me if I can try/test
something to check out this problem.

I have tried disabling dma (hdparm -d0 /dev/hda) but it doesn't help.

Best wishes


Norbert
--
ciao
norb

+-------------------------------------------------------------------+
| Norbert Preining http://www.logic.at/people/preining |
| University of Technology Vienna, Austria preining@logic.at |
| DSA: 0x09C5B094 (RSA: 0xCF1FA165) mail subject: get [DSA|RSA]-key |
+-------------------------------------------------------------------+
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-03-22 12:57    [W:0.032 / U:0.280 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site