lkml.org 
[lkml]   [2001]   [Feb]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: 2.2.18 IDE tape problem, with ide-scsi
Camm Maguire wrote:
>
> Thanks for the error identification. The other drive is of a
> *different* model. This drive showed this behavior from the day I
> bought it. The drive could be going bad, but I doubt it. Is it
> possible that this manufacturer (Conner) has some peculiar
> implementation of the spec? I recall reading on this list sometime
> back of similar workarounds to unusual drives.

Since the non-wroking drive is a different model, other drive working
does not mean the st driver is sending only valid commands to the
drives. st driver is sending a command to this drive which the drive
does not like. It will help to know what that command is.

>
> > st driver prints the SCSI command that may have caused this error only
> > when compiled with debug turned on. Maybe st driver should always print
> > the command that results in a check condition as long as the command is
> > not a Test Unit Ready or Mode Sense.
> >
>
> Can I turn on debug mode in runtime, or do I need to recompile
> ide-scsi?

This is a compile time option, so you will have to recompile "st"
driver. If you look at drivers/scsi/st.c, near the top of the file (line
44 for 2.4.2) you will see a line

#define DEBUG 0

Change this line to set DEBUG to 1 and recompile. This may generate lot
of messages from Test Unit Ready and Mode Sense commands. You can
suppress these messages by replacing the code block within "if
(debugging)" conditional at line 241 with following:

if (SRpnt->sr_cmnd[0] != MODE_SENSE &&
SRpnt->sr_cmnd[0] != TEST_UNIT_READY) {
printk(ST_DEB_MSG "st%d: Error: %x, cmd: %x %x %x %x %x
%x Len: %d\n",
dev, result,
SRpnt->sr_cmnd[0], SRpnt->sr_cmnd[1],
SRpnt->sr_cmnd[2],
SRpnt->sr_cmnd[3], SRpnt->sr_cmnd[4],
SRpnt->sr_cmnd[5],
SRpnt->sr_bufflen);
if (driver_byte(result) & DRIVER_SENSE)
print_req_sense("st", SRpnt);
}


====================================================================
Khalid Aziz Linux Development Laboratory
(970)898-9214 Hewlett-Packard
khalid@fc.hp.com Fort Collins, CO
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-03-22 13:28    [W:0.069 / U:2.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site