[lkml]   [2001]   [Dec]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject2.4.17-pre2 having dma problems with atapi devices
I'm trying to write to a cd at 8x, which i could do in prior kernels
(2.4.15-prex and before), but now i'm getting cdrecord errors and
sometimes dma timeouts. Seems that data is being corrupted somewhere
again. I got this kind of performance when i had it on the promise
controller and when i moved it back to my via controller it worked

Ide controller:
VIA vt82c686a (rev 22) IDE UDMA66 controller

(set as master and DMA set by kernel)

setting to a lower write speed allows successful writes.

cdrecord error:
/usr/bin/cdrecord: Input/output error. send opc: scsi sendcmd: no error
CDB: 54 01 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 03 00 00 00 00 0A 00 00 00 00 73 03 00 00
Sense Key: 0x3 Medium Error, Segment 0
Sense Code: 0x73 Qual 0x03 (power calibration area error) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 17.724s timeout 60s
/usr/bin/cdrecord: Resource temporarily unavailable. OPC failed.
/usr/bin/cdrecord: fifo had 64 puts and 0 gets.
/usr/bin/cdrecord: fifo was 0 times empty and 0 times full, min fill was

The dma errors weren't very special, same old dma timeout and reset
messages. The cds are perfectly fine, i use the same one that errored
at 4x and it reads fine after burn.

To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to
More majordomo info at
Please read the FAQ at

 \ /
  Last update: 2005-03-22 13:13    [W:0.024 / U:1.396 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site