Messages in this thread |  | | Date | Sun, 7 Oct 2001 13:23:49 -0400 | From | Willem Riede <> | Subject | Tyan Tiger MP AMD760 chipset support |
| |
Since Alan Cox wrote months ago:
> 2.4.7ac should be up to date on it
with reference to AMD760 (IDE?) support on a Tyan K7 Thunder, I was somewhat surprised to find the chipset:
AMD-762 North bridge & AMD-766 South bridge Winbond W83627HF Super I/O ASIC Winbond W83782D hardware monitoring ASIC
only partly recognized by my 2.4.9ac18 based kernel. One problem is that the temperature sensors are not detected (I'm reluctant to torture my system if I can't watch out for it overheating).
Does anyone know the AMD760 support status? Any pointers for (experimental) patches?
Here is the lspci -vvv output:
00:00.0 Host bridge: Advanced Micro Devices [AMD]: Unknown device 700c (rev 11) Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort+ >SERR- <PERR- Latency: 64 Region 0: Memory at ec000000 (32-bit, prefetchable) [size=64M] Region 1: Memory at e8006000 (32-bit, prefetchable) [size=4K] Region 2: I/O ports at 10a0 [disabled] [size=4] Capabilities: [a0] AGP version 2.0 Status: RQ=15 SBA+ 64bit- FW+ Rate=x1,x2 Command: RQ=0 SBA+ AGP+ 64bit- FW- Rate=x1
00:01.0 PCI bridge: Advanced Micro Devices [AMD]: Unknown device 700d (prog-if 00 [Normal decode]) Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap- 66Mhz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 99 Bus: primary=00, secondary=01, subordinate=01, sec-latency=68 I/O behind bridge: 00002000-00002fff Memory behind bridge: e8100000-e81fffff Prefetchable memory behind bridge: f0000000-f7ffffff BridgeCtl: Parity- SERR- NoISA+ VGA+ MAbort- >Reset- FastB2B-
00:07.0 ISA bridge: Advanced Micro Devices [AMD] AMD-765 [Viper] ISA (rev 02) Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 0
00:07.1 IDE interface: Advanced Micro Devices [AMD] AMD-765 [Viper] IDE (rev 01) (prog-if 8a [Master SecP PriP]) Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 64 Region 4: I/O ports at f000 [size=16]
00:07.3 Bridge: Advanced Micro Devices [AMD] AMD-765 [Viper] ACPI (rev 01) Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
00:07.4 USB Controller: Advanced Micro Devices [AMD] AMD-765 [Viper] USB (rev 07) (prog-if 10 [OHCI]) Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 16 (20000ns max) Interrupt: pin D routed to IRQ 11 Region 0: Memory at 000dc000 (32-bit, non-prefetchable) [size=4K]
00:0b.0 Unknown mass storage controller: Promise Technology, Inc. 20268 (rev 01) (prog-if 85) Subsystem: Promise Technology, Inc. 20268 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz+ UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 64 (1000ns min, 4500ns max), cache line size 10 Interrupt: pin A routed to IRQ 11 Region 0: I/O ports at 10b8 [size=8] Region 1: I/O ports at 10b0 [size=4] Region 2: I/O ports at 10a8 [size=8] Region 3: I/O ports at 10a4 [size=4] Region 4: I/O ports at 1090 [size=16] Region 5: Memory at e8000000 (32-bit, non-prefetchable) [size=16K] Expansion ROM at <unassigned> [disabled] [size=16K] Capabilities: [60] Power Management version 1 Flags: PMEClk- DSI- D1+ D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=0 PME-
00:0d.0 Ethernet controller: 3Com Corporation 3c905C-TX [Fast Etherlink] (rev 78) Subsystem: 3Com Corporation 3C905C-TX Fast Etherlink for PC Management NIC Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 80 (2500ns min, 2500ns max), cache line size 10 Interrupt: pin A routed to IRQ 5 Region 0: I/O ports at 1000 [size=128] Region 1: Memory at e8005000 (32-bit, non-prefetchable) [size=128] Expansion ROM at <unassigned> [disabled] [size=128K] Capabilities: [dc] Power Management version 2 Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+) Status: D0 PME-Enable- DSel=0 DScale=2 PME-
01:05.0 VGA compatible controller: ATI Technologies Inc: Unknown device 5144 (prog-if 00 [VGA]) Subsystem: ATI Technologies Inc: Unknown device 008a Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping+ SERR- FastB2B+ Status: Cap+ 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 66 (2000ns min), cache line size 10 Interrupt: pin A routed to IRQ 10 Region 0: Memory at f0000000 (32-bit, prefetchable) [size=128M] Region 1: I/O ports at 2000 [size=256] Region 2: Memory at e8100000 (32-bit, non-prefetchable) [size=512K] Expansion ROM at <unassigned> [disabled] [size=128K] Capabilities: [58] AGP version 2.0 Status: RQ=47 SBA+ 64bit- FW- Rate=x1,x2 Command: RQ=15 SBA+ AGP+ 64bit- FW- Rate=x1 Capabilities: [50] Power Management version 2 Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Thanks. Willem Riede. - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
|  |