lkml.org 
[lkml]   [2001]   [Oct]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRE: [PATCH] Re: Lost interrupt with HPT370

hi,
just wanted to let you know that your blacklist of
ata-100 drives for HPT3 is most likely overzealous.

as you state you tested it only with 41gb.

I own
IBM's 61gb IC35L060AVER07-0 drive.
ABIT KG7-RAID with HPT370

First I have been running "Linux version 2.4.2-2" RH7.1
and this sets the above setup to ATA-100 and I had not
experienced any problems.

Once I "upgraded" to 2.4.10 my drive got blacklisted and
runs as ata-44.

to double check, I removed the driver from blacklist for
100 and 66 and recompiled kernel, and it seems to be
running fine so far.

now there's weird part, for both drive running at ATA-44 and ATA-100
I get pretty much same numbers from hdparam. Perhaps it just an change to
printf alone, and drive runs at ata-100 even it if says that it is ata-44
? what kind of numbers should I expect from ATA-100 drive anyway?

hde: 120103200 sectors (61493 MB) w/1916KiB Cache, CHS=119150/16/63, UDMA(44)
dev/hde:
Timing buffer-cache reads: 128 MB in 0.70 seconds =182.86 MB/sec
Timing buffered disk reads: 64 MB in 1.68 seconds = 38.10 MB/sec

hde: 120103200 sectors (61493 MB) w/1916KiB Cache, CHS=119150/16/63, UDMA(100)
/dev/hde:
Timing buffer-cache reads: 128 MB in 0.68 seconds =188.24 MB/sec
Timing buffered disk reads: 64 MB in 1.69 seconds = 37.87 MB/sec

---------------------------------------

ide: Assuming 33MHz system bus speed for PIO modes; override with
idebus=xx
VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt82c686b (rev 40) IDE UDMA100 controller on pci00:07.1
ide0: BM-DMA at 0xc400-0xc407, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xc408-0xc40f, BIOS settings: hdc:DMA, hdd:DMA
HPT370A: IDE controller on PCI bus 00 dev 98
PCI: Found IRQ 11 for device 00:13.0
PCI: Sharing IRQ 11 with 00:09.0
HPT370A: chipset revision 4
HPT370A: not 100% native mode: will probe irqs later
ide2: BM-DMA at 0xe800-0xe807, BIOS settings: hde:DMA, hdf:pio
ide3: BM-DMA at 0xe808-0xe80f, BIOS settings: hdg:pio, hdh:pio
hda: WDC WD272AA, ATA DISK drive
hdc: QPS CD-R PX-W8432T, ATAPI CD/DVD-ROM drive
hdd: LG DVD-ROM DRD-8120B, ATAPI CD/DVD-ROM drive
hde: IC35L060AVER07-0, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
ide2 at 0xd800-0xd807,0xdc02 on irq 11
hda: 53128656 sectors (27202 MB) w/2048KiB Cache, CHS=3307/255/63, UDMA(66)
hde: 120103200 sectors (61493 MB) w/1916KiB Cache, CHS=119150/16/63, UDMA(100)

--
Adam
http://www.eax.com The Supreme Headquarters of the 32 bit registers



-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-03-22 13:04    [W:0.199 / U:0.084 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site