Messages in this thread |  | | From | "andre lourenco" <> | Subject | problem with a copy (cdrom to disk) under 2.4.0 | Date | Fri, 12 Jan 2001 22:25:06 -0000 |
| |
i have a problem:
when i try to copy a big (maybe >200MB) from my CDROM to my disk the system gives me an input/output error...
if I run dmesg i have this:
[root@localhost andyrock]# dmesg Linux version 2.4.0 (root@localhost.localdomain) (gcc version 2.95.3 19991030 (prerelease)) #1 Qui Jan 11 12:22:42 WET 2001 BIOS-provided physical RAM map: BIOS-e820: 000000000009fc00 @ 0000000000000000 (usable) BIOS-e820: 0000000000000400 @ 000000000009fc00 (reserved) BIOS-e820: 0000000000010000 @ 00000000000f0000 (reserved) BIOS-e820: 0000000000010000 @ 00000000ffff0000 (reserved) BIOS-e820: 0000000007f00000 @ 0000000000100000 (usable) Scan SMP from c0000000 for 1024 bytes. Scan SMP from c009fc00 for 1024 bytes. Scan SMP from c00f0000 for 65536 bytes. Scan SMP from c009fc00 for 4096 bytes. On node 0 totalpages: 32768 zone(0): 4096 pages. zone(1): 28672 pages. zone(2): 0 pages. mapped APIC to ffffe000 (01223000) Kernel command line: mem=131072K root=/dev/hdb5 ide1=autotune ide0=autotune ide_setup: ide1=autotune ide_setup: ide0=autotune Initializing CPU#0 Detected 334.095 MHz processor. Console: colour dummy device 80x25 Calibrating delay loop... 666.82 BogoMIPS Memory: 126340k/131072k available (1215k kernel code, 4344k reserved, 472k data, 220k init, 0k highmem) Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes) Buffer-cache hash table entries: 8192 (order: 3, 32768 bytes) Page-cache hash table entries: 32768 (order: 5, 131072 bytes) Inode-cache hash table entries: 8192 (order: 4, 65536 bytes) VFS: Diskquotas version dquot_6.4.0 initialized CPU: Before vendor init, caps: 0183f9ff 00000000 00000000, vendor = 0 CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 512K Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: After vendor init, caps: 0183f9ff 00000000 00000000 00000000 CPU: After generic, caps: 0183f9ff 00000000 00000000 00000000 CPU: Common caps: 0183f9ff 00000000 00000000 00000000 CPU: Intel Pentium II (Deschutes) stepping 01 Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.37 (20001109) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: Intel PCI: PCI BIOS revision 2.10 entry at 0xfb2b0, last bus=1 PCI: Using configuration type 1 PCI: Probing PCI hardware Unknown bridge resource 2: assuming transparent Limiting direct PCI/PCI transfers. isapnp: Scanning for Pnp cards... isapnp: Card 'ESS ES1868 Plug and Play AudioDrive' isapnp: 1 Plug & Play card detected total Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket DMI 2.0 present. 32 structures occupying 792 bytes. DMI table at 0x000F0800. BIOS Vendor: Award Software International, Inc. BIOS Version: 4.51 PG BIOS Release: 08/10/98 Starting kswapd v1.8 vesafb: framebuffer at 0xe5400000, mapped to 0xc8800000, size 4096k vesafb: mode is 800x600x16, linelength=1600, pages=3 vesafb: protected mode interface info at c000:1759 vesafb: scrolling: redraw vesafb: directcolor: size=0:5:6:5, shift=0:11:5:0 Console: switching to colour frame buffer device 100x37 fb0: VESA VGA frame buffer device pty: 256 Unix98 ptys configured Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx PIIX4: IDE controller on PCI bus 00 dev 39 PIIX4: chipset revision 1 PIIX4: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:pio, hdb:pio ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:pio ide3: ESS ES1868 Plug and Play AudioDrive IDE interface hda: FUJITSU MPE3170AT, ATA DISK drive hdb: QUANTUM FIREBALL EX3.2A, ATA DISK drive hdc: TOSHIBA CD-ROM XM-6402B, ATAPI CDROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: 33360580 sectors (17081 MB) w/512KiB Cache, CHS=2076/255/63 hdb: 6306048 sectors (3229 MB) w/418KiB Cache, CHS=782/128/63, UDMA(33) hdc: ATAPI 32X CD-ROM drive, 256kB Cache, UDMA(33) Uniform CD-ROM driver Revision: 3.12 Partition check: hda: hda1 hda2 < hda5 > hda3 hda4 hdb: hdb1 hdb2 < hdb5 > Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 udf: registering filesystem Serial driver version 5.02 (2000-08-09) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A PPP generic driver version 2.4.1 PPP Deflate Compression module registered PPP BSD Compression module registered [drm] Initialized tdfx 1.0.0 20000928 on minor 63 es1371: version v0.27 time 12:26:33 Jan 11 2001 usb.c: registered new driver usbdevfs usb.c: registered new driver hub uhci.c: USB UHCI at I/O 0xe000, IRQ 9 uhci.c: detected 2 ports usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected mice: PS/2 mouse device common for all mice NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 1024 buckets, 8Kbytes TCP: Hash tables configured (established 8192 bind 8192) ip_conntrack (1024 buckets, 8192 max) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 220k freed Adding Swap: 128516k swap-space (priority -1) Soundblaster audio driver Copyright (C) by Hannu Savolainen 1993-1996 sb: ESS ES1868 Plug and Play AudioDrive detected sb: ISAPnP reports 'ESS ES1868 Plug and Play AudioDrive' at i/o 0x220, irq 5, dma 1, 3 SB 3.01 detected OK (220) ESS chip ES1868 detected sb: ESS ES1868 Plug and Play AudioDrive detected sb: Failed to initialize ESS ES1868 Plug and Play AudioDrive sb: 1 Soundblaster PnP card(s) found. YM3812 and OPL-3 driver Copyright (C) by Hannu Savolainen, Rob Hooft 1993-1996 0x378: FIFO is 16 bytes 0x378: writeIntrThreshold is 16 0x378: readIntrThreshold is 16 0x378: PWord is 8 bits 0x378: Interrupts are ISA-Pulses 0x378: ECP port cfgA=0x10 cfgB=0x48 0x378: ECP settings irq=7 dma=<none or set by other means> parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE,COMPAT,EPP,ECP] parport0: irq 7 detected parport0: cpp_mux: aa55f00f52ad51(07) parport0: Found 1 daisy-chained devices lp0: using parport0 (polling). hdc: irq timeout: status=0xd0 { Busy } hdc: DMA disabled hdc: ATAPI reset complete VFS: Disk change detected on device ide1(22,0) ISO 9660 Extensions: Microsoft Joliet Level 3 ISOFS: changing to secondary root isofs_read_level3_size: More than 100 file sections ?!?, aborting... isofs_read_level3_size: inode=45152 ino=53408 isofs_read_level3_size: More than 100 file sections ?!?, aborting... isofs_read_level3_size: inode=45232 ino=53488 hdc: command error: status=0x51 { DriveReady SeekComplete Error } hdc: command error: error=0x51 hdc: command error: status=0x51 { DriveReady SeekComplete Error } hdc: command error: error=0x51 end_request: I/O error, dev 16:00 (hdc), sector 18468 hdc: command error: status=0x51 { DriveReady SeekComplete Error } hdc: command error: error=0x51 end_request: I/O error, dev 16:00 (hdc), sector 18472 hdc: command error: status=0x51 { DriveReady SeekComplete Error } hdc: command error: error=0x51 end_request: I/O error, dev 16:00 (hdc), sector 18476 hdc: command error: status=0x51 { DriveReady SeekComplete Error } hdc: command error: error=0x51 end_request: I/O error, dev 16:00 (hdc), sector 18480 hdc: command error: status=0x51 { DriveReady SeekComplete Error } hdc: command error: error=0x51 end_request: I/O error, dev 16:00 (hdc), sector 18484 hdc: command error: status=0x51 { DriveReady SeekComplete Error } hdc: command error: error=0x51 end_request: I/O error, dev 16:00 (hdc), sector 18488 hdc: command error: status=0x51 { DriveReady SeekComplete Error } hdc: command error: error=0x51 end_request: I/O error, dev 16:00 (hdc), sector 18492 hdc: command error: status=0x51 { DriveReady SeekComplete Error } hdc: command error: error=0x51 end_request: I/O error, dev 16:00 (hdc), sector 18468 hdc: command error: status=0x51 { DriveReady SeekComplete Error } hdc: command error: error=0x51 end_request: I/O error, dev 16:00 (hdc), sector 18472 hdc: command error: status=0x51 { DriveReady SeekComplete Error } hdc: command error: error=0x51 end_request: I/O error, dev 16:00 (hdc), sector 18468 hdc: command error: status=0x51 { DriveReady SeekComplete Error } hdc: command error: error=0x51 end_request: I/O error, dev 16:00 (hdc), sector 18472 [root@localhost andyrock]#
do you know what is this? thank's,
Andre Lourenco
ver_linux: Linux localhost.localdomain 2.4.0 #2 Qui Jan 11 19:34:32 WET 2001 i686 unknown Kernel modules 2.4.1 Gnu C 2.95.3 Gnu Make 3.79.1 Binutils 2.10.0.24 Linux C Library 2.1.3 Dynamic linker ldd (GNU libc) 2.1.3 Procps 2.0.7 Mount 2.10o Net-tools 1.57 Console-tools 0.2.3 Sh-utils 2.0 Modules Loaded parport_pc lp parport nfsd lockd sunrpc autofs opl3 sb sb_lib uart401 sound nls_iso8859-1 nls_cp437 vfat fat
_________________________________________________________ Do You Yahoo!? Get your free @yahoo.com address at http://mail.yahoo.com
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org Please read the FAQ at http://www.tux.org/lkml/
|  |