Messages in this thread | | | Date | 1 Mar 2000 9:12:5 +0100 | From | "Rask Ingemann Lambertsen" <> | Subject | Re: Problem: Not configure hde on HPT366 (on ABIT BP6). |
| |
Den 01-Mar-00 07:02:50 skrev Georgios Kossionis følgende om "Re: Problem: Not configure hde on HPT366 (on ABIT BP6).": [cut] > More specifically i used the following values at the lilo prompt:
> 1) LILO: <kernel_name> ide2=0xb000,0xb406 ide3=0xbc00,0xc006 > 2) LILO: <kernel_name> ide2=0xb000,0x0 ide3=0xbc00,0x0 > and 3) LILO: <kernel_name> ide2=0xb000 ide3=0xbc00 [cut] > At the boot process the following appears with 2 & 3 from the above > values:
What happens with 1)?
[cut] > hde: probing with STATUS(0x50) instead of ALTSTATUS(0xff) > hde: ST328040A, ATA DISK drive > hdf: probing with STATUS(0x00) instead of ALTSTATUS(0xff) > hdf: probing with STATUS(0x00) instead of ALTSTATUS(0xff) > ide2 at 0xb000-0xb007,0xb206 on irq 15 ^^^^^^ Odd. It looks as if that ninth port is more or less hard coded to be at 0x0206 after the first one.
Don't you get one more line with something like
hde: ST328040A, 28040 MB w/xxxkB Cache, CHS=xxxxx/xxx/xx
?
> Any further comments or sugestion are valuable.
Well, just two more wild shots:
ide2=0xb400,0x0 ide3=0xc000,0x0
ide2=0xb400,0xb006 ide3=0xc000,0xbc06
Regards,
/¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯T¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯\ | Rask Ingemann Lambertsen | E-mail: mailto:rask@kampsax.k-net.dk | | Registered Phase5 developer | WWW: http://www.gbar.dtu.dk/~c948374/ | | A4000, 896 kkeys/s (RC5-64) | "ThrustMe" on XPilot, ARCnet and IRC | | Es funktioniert nicht, sieht aber gut aus. |
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
| |