Messages in this thread |  | | Date | Wed, 06 Dec 2000 16:05:00 -0800 | From | Miles Lane <> | Subject | Re: test12-pre6 |
| |
Erik Mouw wrote:
> On Wed, Dec 06, 2000 at 11:38:30AM -0800, Linus Torvalds wrote: > >> But I see something obviously wrong there: you have busmaster disabled. >> >> Looking into the UHCI controller code, I notice that neither UHCI driver >> actually does the (required) >> >> pci_set_master(dev); >> >> Please add that to just after a successful "pci_enable_device(dev)", and I >> just bet your USB will start working.
I tested this change applied to usb-ohci. I did not fix the problem where eth0 spits out a ton of error messages:
eth0: Host error, FIFO diagnostic register 0000. eth0: using default media MII eth0: Host error, FIFO diagnostic register 0000. eth0: using default media MII eth0: Too much work in interrupt, status e003. eth0: Host error, FIFO diagnostic register 0000. eth0: using default media MII
This error occurs when I am trasfering data over my DSL connection while moving my USB mouse.
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org Please read the FAQ at http://www.tux.org/lkml/
|  |