[lkml]   [1999]   [Sep]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    SubjectRe: Getting ISDN Card working (was vendor ID in /proc/pci)
    On Wed 29 Sep 1999, Paul Slootman wrote:
    > The right mailing list would be (cc'ed in
    > this message).

    This should of course have been Oops.

    > >my card was a Datalink but that is as far as I managed to get. I managed to
    > >lay my hands on some drivers for the dynalink card built against 2.2.12. I
    > >tried to load these using modprobe hisax but this just comes pack with
    > >
    > >/lib/modules/2.2.12/misc/isdn.o: init_module: Device or resource busy
    > >isdn: No such file or directory
    > >
    > >however dmesg shows
    > >
    > >ISDN subsystem Rev: 1.86/1.72/1.88/1.49/1.16/1.2
    > [...]
    > >HiSax: Card 1 Protocol 1TR6 Id=HiSAX (0)
    > >HiSax: Support for ISDNLink Card not selected
    > This means that the hisax module was not configured for the ISDNLink
    > card (this is configured when configuring the kernel). I.e. the config
    > needs to be changed, and the module recompiled.
    > Also, I see it says "Protocol 1TR6", which I believe is not what you
    > want for the UK (or in fact almost anywhere). Pass the "protocol=2"
    > parameter.

    Paul Slootman

    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to
    Please read the FAQ at

     \ /
      Last update: 2005-03-22 13:54    [W:0.021 / U:17.656 seconds]
    ©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site