lkml.org 
[lkml]   [1999]   [Apr]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
Subjectaic7xxx (5.1.13) with 2930U2
I'm getting a lot of these messages (about 1-2 per day):
Apr 21 14:00:52 anjala kernel: scsi : aborting command due to timeout : pid 536932, scsi0, channel 0, id 0, lun 0 Read (6) 12 e3 52 08 00
Apr 21 14:00:53 anjala kernel: SCSI host 0 abort (pid 536932) timed out - resetting
Apr 21 14:00:53 anjala kernel: SCSI bus is being reset for host 0 channel 0.
Apr 21 14:00:56 anjala kernel: (scsi0:0:0:0) Synchronous at 40.0 Mbyte/sec, offset 15.

(btw, why is the pid so high? some occur with reasonable pid's too: 2000ish)
The numbers after the Read (6) are variable.

boot messages:
(scsi0) <Adaptec AHA-293X Ultra2 SCSI host adapter> found at PCI 12/0
(scsi0) Wide Channel, SCSI ID=7, 32/255 SCBs
(scsi0) Downloading sequencer code... 407 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.13/3.2.4
<Adaptec AHA-293X Ultra2 SCSI host adapter>
scsi : 1 host.
Vendor: IBM Model: DGVS09Y Rev: 03B0
Type: Direct-Access ANSI SCSI revision: 03
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
(scsi0:0:0:0) Synchronous at 40.0 Mbyte/sec, offset 15.
scsi : detected 1 SCSI disk total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 17829870 [8705 MB] [8.7 GB]

Kernel is 2.2.5 with the 5.1.13 aic7xxx patch.

-- arvind

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-03-22 13:51    [W:0.036 / U:0.272 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site