Messages in this thread | | | From | Andrzej Krzysztofowicz <> | Subject | Re: [2.3.26] Using "idex/hdx" params from lilo, still a dream? | Date | Tue, 9 Nov 1999 11:33:30 -0022 (MET) |
| |
> > Andre Hedrick wrote: > > > > Well they should be there since I use them also for new hardware. > > Unfortunately not here, see what happen with 2.2.12 and 2.3.26 > using the _same_ "hdc=none" boot parameter : > > Good 2.2.12 boot: > ----------------- > hda: WDC AC24300L, ATA DISK drive > hdb: CRD-8322B, ATAPI CDROM drive > ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 > hda: WDC AC24300L, 4112MB w/256kB Cache, CHS=524/255/63, UDMA > hdb: ATAPI 32X CD-ROM drive, 128kB Cache > > Bad 2.3.26 boot: > ---------------- > hda: WDC AC24300L, ATA DISK drive > hdb: CRD-8322B, ATAPI CDROM drive > hdc: WDC AC24300L, ATA DISK drive > ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 > ide1 at 0x170-0x177,0x376 on irq 15 > hda: WDC AC24300L, 4112MB w/256kB Cache, CHS=524/255/63, UDMA(33) > hdc: WDC AC24300L, 4112MB w/256kB Cache, CHS=8912/15/63, UDMA(33) > hdb: ATAPI 32X CD-ROM drive, 128kB Cache, DMA > > As you can see 2.3.26 didn't show "ide_setup: hdc=none" debug line > and I repeat, all hdx/idex cmdline was ignored :( >
idebus=... parameter (for PCI bus speed) is also ignored.
-- ======================================================================= Andrzej M. Krzysztofowicz ankry@mif.pg.gda.pl phone (48)(58) 347 14 61 Faculty of Applied Phys. & Math., Technical University of Gdansk
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
| |