Messages in this thread | | | Subject | Re: ultra2 scsi support? | From | Philippe Troin <> | Date | 22 Oct 1999 12:37:17 -0700 |
| |
nbecker@fred.net writes:
> Is ultra2 scsi supported? > > I see a comment about 40.0MB/sec below. This is an ultra2 card, > cable, and tape drive. Should it say 80.0MB/sec? > > > Oct 22 08:55:23 rpppc2 kernel: (scsi0) <Adaptec AHA-294X Ultra2 SCSI host adapter> found at PCI 16/0 > Oct 22 08:55:23 rpppc2 kernel: (scsi0) Wide Channel, SCSI ID=7, 32/255 SCBs > Oct 22 08:55:23 rpppc2 kernel: (scsi0) Downloading sequencer code... 374 instructions downloaded > Oct 22 08:55:23 rpppc2 kernel: scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.20/3.2.4 > Oct 22 08:55:23 rpppc2 kernel: <Adaptec AHA-294X Ultra2 SCSI host adapter> > Oct 22 08:55:23 rpppc2 kernel: scsi : 1 host. > Oct 22 08:55:23 rpppc2 kernel: (scsi0:0:0:0) Synchronous at 40.0 Mbyte/sec, offset 15. > Oct 22 08:55:23 rpppc2 kernel: Vendor: SONY Model: SDT-10000 Rev: 0101 > Oct 22 08:55:23 rpppc2 kernel: Type: Sequential-Access ANSI SCSI revision: 02
AFAIK, the SDT-10000 is an Ultra SCSI drive, not Ultra-2.
Phil.
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
| |