Messages in this thread Patch in this message | | | Date | Sat, 2 May 1998 19:42:45 -0400 (EDT) | From | ADAM Sulmicki <> | Subject | 2.1.99 [xd,isdn,kmod] : XT disk driver [patches] (fwd) |
| |
Anyone cares to apply the patch attached below to 2.1.99 .. the problem still exist and I'm trying to build all-modules-inclued-kernel.
---------- Forwarded message ---------- From: Andrzej Krzysztofowicz <ankry@green.mif.pg.gda.pl> To: linux-kernel@vger.rutgers.edu Date: Thu, 9 Apr 1998 13:29:10 +0200 (CEST) Subject: XT disk driver [patches]
I attach corrected versions of xd.c patches against 2.1.9[34] and Alan's 2.0.34pre7. Please don't apply previous patches (they are buggy).
************************************************************************ diff --unified --new-file --recursive --exclude-from exclude linux.vanilla/drivers/block/xd.c linux/drivers/block/xd.c --- linux-2.1.93/drivers/block/xd.c.old Wed Apr 8 20:12:26 1998 +++ linux/drivers/block/xd.c Wed Apr 8 20:28:12 1998 @@ -706,8 +706,7 @@ switch (address) { case 0x00000: case 0xC8000: break; /*initial: 0x320 */ - case 0xCA000: if (xd[3]<=0) xd_iobase = 0x324; - break; + case 0xCA000: xd_iobase = 0x324; case 0xD0000: /*5150CX*/ case 0xD8000: break; /*5150CX & 5150XL*/ default: printk("xd_dtc_init_controller: unsupported BIOS address %06x\n",address); ************************************************************************ ---------- End of Forwarded message ----------
Another problem is with ISDN HISAX, they like to fail to compile for any reason [say you can't inlucd generic hisax support only]
Finally, does anyone has suggestion what could be causing the following error? [see last two lines]
Linux version 2.1.99 (root@styx.sulmicki.erols.com) (gcc version 2.7.2.3) #1 SMP Sat May 2 00:32:15 EDT 1998 Console: 16 point font, 400 scans Console: colour VGA+ 80x25, 1 virtual console (max 63) Calibrating delay loop... 132.71 BogoMIPS Memory: 63116k/65528k available (840k kernel code, 400k reserved, 1136k data, 36k init) Checking if this processor honours the WP bit even in supervisor mode... Ok. Swansea University Computer Society NET3.039 for Linux 2.1 Swansea University Computer Society TCP/IP for NET3.037 IP Protocols: ICMP, UDP, TCP Checking 386/387 coupling... Ok, fpu using exception 16 error reporting. Checking 'hlt' instruction... Ok. POSIX conformance testing by UNIFIX CPU0: Cyrix 6x86MX 2.5x Core/Bus Clock stepping 04 SMP motherboard not detected. Using dummy APIC emulation. PCI: PCI BIOS revision 2.10 entry at 0xfb1b0 PCI: Using configuration type 1 PCI: Probing PCI hardware. Starting kswapd v 1.5 Serial driver version 4.25 with enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A APM BIOS version 1.2 Flags 0x07 (Driver version 1.4) Entry f000:80b0 cseg16 f000 dseg fdfc cseg len e6ff, cseg16 len 0, dseg len 0 Connection version 1.2 AC on line, battery status unknown, battery life unknown battery flag 0x80, battery life unknown PIIX4: IDE controller on PCI bus 00 dev 39 PIIX4: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:pio, hdb:pio ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:pio hda: WDC AC36400L, ATA DISK drive hdc: CD-532E, ATAPI CDROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: WDC AC36400L, 6149MB w/256kB Cache, CHS=784/255/63, UDMA Partition check: hda: hda1 hda2 < hda5 hda6 hda7 hda8 > hda3 hda4 < hda9 hda10 hda11 hda12 > VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 36k freed Adding Swap: 130748k swap-space (priority -1) VFS: file-max limit 4096 reached kmod: failed to exec /sbin/modprobe -s -k net-pf-1, errno = 23
-Adam
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu
| |