Messages in this thread | | | Date | Sat, 22 Nov 1997 12:16:22 -0800 | From | "Allen K. Smith" <> | Subject | Stallion EC 8/64-AT under 2.1.65 |
| |
Is this driver supposed to work with this card under 2.1.65?
This in the ISA version version of the easyconnect board. It works like a charm under 2.0.3x, however I get an error message about invalid rom under 2.1.65. I pulling down the latest firmware and stlload from ftp.stallion.com, and compiled the utilities under the correct kernel, but I get the same message.
2.0.3x recognizes the board as follows, 2.1.65 recognizes it with the same numbers/addresses.
STALLION: EC8/64-AT found, unit=0 io=2a0 mem=cc000 nrpanels=1 nrports=1
The exact error message given is:
./stlload: read of ROM signature failed, errno=1062840300
If i run it by hand several times I get the following:
router-205-64# ./stlload -v -v -v cdk.sys Using shared memory device /dev/staliomem0 Downloading image /usr/local/stallion/cdk.sys to board 0 Opening shared memory device /dev/staliomem0 Stoping any current slave Reseting the board Interrupting board to activate shared memory Opening slave image file /usr/local/stallion/cdk.sys Reading ROM signature from board ./stlload: read of ROM signature failed, errno=1062841260 router-205-64# ./stlload -v -v -v cdk.sys Using shared memory device /dev/staliomem0 Downloading image /usr/local/stallion/cdk.sys to board 0 Opening shared memory device /dev/staliomem0 Stoping any current slave Reseting the board Interrupting board to activate shared memory Opening slave image file /usr/local/stallion/cdk.sys Reading ROM signature from board ./stlload: read of ROM signature failed, errno=1062840300
dmesg gives me lots of these :
stlload: Exception at [<c019054a>] cr2=1c01e (fixup: c019a2a5) stlload: Exception at [<c019054a>] cr2=1d01e (fixup: c019a2a5) stlload: Exception at [<c019054a>] cr2=1e01e (fixup: c019a2a5) stlload: Exception at [<c019054a>] cr2=1f01e (fixup: c019a2a5)
Allen Smith, lazlor@stardust.com IP Multicast. Turn it on and tune-in to the future.
| |