lkml.org 
[lkml]   [1996]   [Jun]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: Linux 2.0.0 NCR scsi instability
Date
In article <4qk18r$md3@freya.yggdrasil.com>,
Adam J. Richter <adam@adam.yggdrasil.com> wrote:
>In article <199606222011.WAA27404@ceres.tat.physik.uni-tuebingen.de>,
>Harald Koenig <koenig@tat.physik.uni-tuebingen.de> wrote:
>>> I get all sorts of interesting error messages, like scsi commands
>>> timing out, resetting scsi bus, and so on when I run the Linux 2.0.0
>>
>>did you allow DISCONNECTs (CONFIG_SCSI_NCR53C7xx_DISCONNECT set) ?
>
> CONFIG_SCSI_NCR53C7xx_DISCONNECT is not set, and the hard disk

I'd suggest looking at or replacing the SCSI cable. If that doesn't
work, swap in a new controller. I'm using a different motherboard
than you, but the NCR53c810 has been bulletproof under all types
of load.



\
 
 \ /
  Last update: 2005-03-22 13:37    [W:0.072 / U:0.096 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site