Messages in this thread |  | | From | "S. G. Sanjay" <> | Subject | Problems in 2.0.0 | Date | Fri, 14 Jun 1996 13:41:38 +0530 (IST) |
| |
Hello all,
I just upgraded my system to 2.0.0 and am facing a few problems :( As I have just recently joined the mailing list, please forgive me if these problems were already discussed on the list.
1) ping/telnet to LOCAL HOST ( 144.16.64.10 ) says :
Trying 144.16.64.10... telnet: Unable to connect to remote host: Network is unreachable
talk also fails saying :
[Error on write to talk daemon : Network is unreachable (101)]
2) We are trying to set up MBONE on our campus. I got mrouted ver-3.8 and tried to run it but I get the following error message :
11:31:29.635 mrouted version 3.8 16:07:06.684 can't enable Multicast routing in kernel: Protocol not available
I have attached the login messages where it says that IGMP is enabled and so is tunneling.
I was advised to upgrade to 2.0.0 when I posted a query yesterday. The problem persists even after doing so.
ifconfig eth0 says multicast is running :
mpeg:sanjay > ifconfig eth0
eth0 Link encap:10Mbps Ethernet HWaddr 00:80:C8:14:41:CD inet addr:144.16.64.10 Bcast:144.16.64.255 Mask:255.255.224.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:137914 errors:0 dropped:0 overruns:0 TX packets:9547 errors:0 dropped:0 overruns:0 Interrupt:5 Base address:0x300
What should I do ? Thanks for all the help in advance ;)
Sanjay ----------------------------------------------------------------------- mpeg:sanjay > cat dmesg >> /tmp/snd.5022
Console: 16 point font, 400 scans Console: colour VGA+ 80x25, 1 virtual console (max 63) Calibrating delay loop.. ok - 33.18 BogoMIPS Memory: 14836k/16384k available (676k kernel code, 384k reserved, 488k data) This processor honours the WP bit even when in supervisor mode. Good. Swansea University Computer Society NET3.035 for Linux 2.0 NET3: Unix domain sockets 0.12 for Linux NET3.035. Swansea University Computer Society TCP/IP for NET3.034 IP Protocols: IGMP, ICMP, UDP, TCP, IPIP VFS: Diskquotas version dquot_5.6.0 initialized Checking 386/387 coupling... Ok, fpu using exception 16 error reporting. Checking 'hlt' instruction... Ok. Linux version 2.0.0 (root@mpeg.ece.iisc.ernet.in) (gcc version 2.7.2) #1 Fri Jun 14 10:22:50 IST 1996 Serial driver version 4.13 with no serial options enabled tty00 at 0x03f8 (irq = 4) is a 16450 tty01 at 0x02f8 (irq = 3) is a 16450 Ramdisk driver initialized : 16 ramdisks of 4096K size hda: ST3660A, 520MB w/120kB Cache, LBA, CHS=1057/16/63 hdb: FX400E, ATAPI CDROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Floppy drive(s): fd0 is 1.44M, fd1 is 1.2M Started kswapd v 1.4.2.2 FDC 0 is an 8272A tunnel: version v0.2b2 ne.c:v1.10 9/23/94 Donald Becker (becker@cesdis.gsfc.nasa.gov) NE*000 ethercard probe at 0x300: 00 80 c8 14 41 cd eth0: NE2000 found at 0x300, using IRQ 5. Partition check: hda: hda1 hda2 VFS: Mounted root (ext2 filesystem) readonly. Adding Swap: 24692k swap-space
============================================================================
email : sanjay@mpeg.ece.iisc.ernet.in
|  |