Messages in this thread |  | | Date | Thu, 2 May 1996 12:32:34 -0500 | From | David A Willmore <> | Subject | Re: On the topic of noisy drivers... |
| |
On May 1, 10:20pm, Mike McLagan wrote: > For the record, the line or two about drives is *NOT* the problem that I was > mentioning originally. I was refering more to this: > > aic7xxx: Chip reset not cleared; clearing manually. > aic7xxx: Extended translation disabled. > aic7xxx: AHA-2740 Rev C and previous. > aic7xxx: Using 4 SCB's; No SCB memory check. > aic7xxx: Using level sensitive interrupts. > aic7xxx: Enabled channel B of AHA-2740-Twin. > AHA-2740-TWIN AT EISA SLOT 1: > irq 14 > bus release time 60 bclks > data fifo threshold 100 > SCSI CHANNEL A: > scsi id 7 > scsi selection timeout 256 ms > scsi bus reset at power-on enabled > scsi bus parity enabled > scsi bus termination (low byte) enabled > aic7xxx: Downloading sequencer code...done. > aic7xxx: Resetting the SCSI bus...done. > scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 2.22/2.2/2.8 > scsi : 1 host. > aic7xxx: Scanning channel A for devices. > aic7xxx: Target 0, channel A, now synchronous at 10.0MHz, offset(0xf). > Vendor: MICROP Model: 1548-15MZ1077810 Rev: HZ2P > Type: Direct-Access ANSI SCSI revision: 01 CCS > Detected scsi disk sda at scsi0, channel 0, id 0, lun 0 > aic7xxx: Target 6, channel A, now synchronous at 4.0MHz, offset(0xf). > Vendor: TOSHIBA Model: CD-ROM XM-3401TA Rev: 2873 > Type: CD-ROM ANSI SCSI revision: 02 > Detected scsi CD-ROM sr0 at scsi0, channel 0, id 6, lun 0 > aic7xxx: Scanning channel B for devices. > scsi : detected 1 SCSI cdrom 1 SCSI disk total. > SCSI Hardware sector size is 512 bytes on device sda > > > I think that this is excessive.
I agree. I get three lines of this/drive. Later, I get one line/drive for hardware sector size. Later, yet, I get one line/drive for partition information. I'm going to see if I can hack some of this to be more terse.
Cheers, David
|  |