Messages in this thread |  | | Date | Wed, 15 May 1996 12:22:22 -0400 | From | "Sheldon E. Newhouse" <> | Subject | different eth0 messages |
| |
I am running 1.99.4 with a WD8013 as eth0.
On boot up, I get the message
wd.c:v1.10 9/23/94 Donald Becker (becker@cesdis.gsfc.nasa.gov) eth0: WD80x3 at 0x300, 00 00 C0 59 F2 80 WD8013, IRQ 10, shared memory at 0xdc000-0xdffff.
But ifconfig gives
eth0 Link encap:10Mbps Ethernet HWaddr 00:00:C0:59:F2:80 inet addr:35.8.158.242 Bcast:35.8.158.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:315 errors:0 dropped:0 overruns:0 TX packets:234 errors:0 dropped:0 overruns:0 Interrupt:10 Base address:0x310 Memory:dc000-e0000
So, one gives 0x300 as base address and the other as 0x310. Don't notice any performance problem though
Just reporting.
-sen
--------------------------------------------------------------------------- | Sheldon E. Newhouse | mail: newhouse@math.msu.edu | | Mathematics Department | www: http://www.mth.msu.edu/~sen | | Michigan State University | telephone: 517-355-9684 | | E. Lansing, MI 48824-1027 USA | FAX: 517-432-1562 | ---------------------------------------------------------------------------
|  |