Messages in this thread |  | | Date | Wed, 15 May 1996 16:17:06 -0700 | From | Clint Marek <> | Subject | Re: different eth0 messages |
| |
Sheldon E. Newhouse wrote: > > I am running 1.99.4 with a WD8013 as eth0. > > On boot up, I get the message > > wd.c:v1.10 9/23/94 Donald Becker (becker@cesdis.gsfc.nasa.gov) > eth0: WD80x3 at 0x300, 00 00 C0 59 F2 80 WD8013, IRQ 10, shared memory at 0xdc000-0xdffff. > > But ifconfig gives > > eth0 Link encap:10Mbps Ethernet HWaddr 00:00:C0:59:F2:80 > inet addr:35.8.158.242 Bcast:35.8.158.255 Mask:255.255.255.0 > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:315 errors:0 dropped:0 overruns:0 > TX packets:234 errors:0 dropped:0 overruns:0 > Interrupt:10 Base address:0x310 Memory:dc000-e0000 > > So, one gives 0x300 as base address and the other as 0x310. > Don't notice any performance problem though
Also notice the shared memory difference (although not much different!): 0xdc000-0xdffff versus 0xdc000-oxe0000.
Clint
|  |