lkml.org 
[lkml]   [1996]   [Nov]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectCDU-8002 + PAS fails on v2.0.0..v2.0.25
Date

I did not pick this up during the 1.3 kernel development phase (my primary
system at that time had an ATAPI CD-ROM) but something was broken after 1.2.13.
I cannot even give any kernel oops messages as the system either locks up solid
or the console streams an infinite string of [number] fields.

My system is an EXP8449 m/b with an AMD 5x86-P75 @ 133MHz, 32MB EDO RAM,
ALI 1487/1489 chipset. The SCSI card is a Pro Audio Spectrum Plus (not a 16).
Other devices on the SCSI bus work fine. The CD-ROM is a single speed device
as used by Apple in the CD-SC+ and CD-150 drives.

scsi0 : at 0x0388 irq 10 options CAN_QUEUE=32 CMD_PER_LUN=2 release=3 generic options AUTOPROBE_IRQ AUTOSENSE PSEUDO DMA UNSAFE generic release=7
scsi0 : Pro Audio Spectrum-16 SCSI
scsi : 1 host.
Vendor: SONY Model: CD-ROM CDU-8002 Rev: 1.8g
Type: CD-ROM ANSI SCSI revision: 01 CCS
Detected scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0
Vendor: ARCHIVE Model: VIPER 150 21531 Rev: -004
Type: Sequential-Access ANSI SCSI revision: 01
Detected scsi tape st0 at scsi0, channel 0, id 1, lun 0
Vendor: INSITE Model: I325VM *F Rev: 0384
Type: Direct-Access ANSI SCSI revision: 01 CCS
Detected scsi removable disk sda at scsi0, channel 0, id 2, lun 0
Unlocked floptical drive.
scsi : detected 1 SCSI tape 1 SCSI cdrom 1 SCSI disk total.

Under 1.2.13 (Slackware from the April 96 InfoMagic set) the CD-ROM works
perfectly. I was not able to install 2.0.0 (Slackware96 from Sept 96 InfoMagic)
until I put the CD in another system and used NFS to install.
--
David Wilson Dept CompSci Uni Wollongong Australia david@cs.uow.edu.au

\
 
 \ /
  Last update: 2005-03-22 13:38    [W:1.115 / U:0.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site