Messages in this thread | | | Date | Wed, 31 May 2023 14:30:19 +0800 | Subject | Re: [PATCH v5 3/3] riscv: dts: starfive: add the node and pins configuration for tdm | From | Walker Chen <> |
| |
On 2023/5/31 14:23, Hal Feng wrote: > On Fri, 26 May 2023 22:54:02 +0800, Walker Chen wrote: >> Add the tdm controller node and pins configuration of tdm for the >> StarFive JH7110 SoC. >> >> Signed-off-by: Walker Chen <walker.chen@starfivetech.com> >> --- >> .../jh7110-starfive-visionfive-2.dtsi | 40 +++++++++++++++++++ >> arch/riscv/boot/dts/starfive/jh7110.dtsi | 21 ++++++++++ >> 2 files changed, 61 insertions(+) >> >> diff --git a/arch/riscv/boot/dts/starfive/jh7110-starfive-visionfive-2.dtsi b/arch/riscv/boot/dts/starfive/jh7110-starfive-visionfive-2.dtsi >> index 1155b97b593d..19b5954ee72d 100644 >> --- a/arch/riscv/boot/dts/starfive/jh7110-starfive-visionfive-2.dtsi >> +++ b/arch/riscv/boot/dts/starfive/jh7110-starfive-visionfive-2.dtsi >> @@ -214,6 +214,40 @@ >> slew-rate = <0>; >> }; >> }; >> + >> + tdm0_pins: tdm0-pins { >> + tdm0-pins-tx { > > Use consistent naming, so > > tdm_pins: tdm-0 { > tx-pins { > >> + pinmux = <GPIOMUX(44, GPOUT_SYS_TDM_TXD, >> + GPOEN_ENABLE, >> + GPI_NONE)>; >> + bias-pull-up; >> + drive-strength = <2>; >> + input-disable; >> + input-schmitt-disable; >> + slew-rate = <0>; >> + }; >> + >> + tdm0-pins-rx { > > rx-pins { > >> + pinmux = <GPIOMUX(61, GPOUT_HIGH, >> + GPOEN_DISABLE, >> + GPI_SYS_TDM_RXD)>; >> + input-enable; >> + }; >> + >> + tdm0-pins-sync { > > sync-pins { > >> + pinmux = <GPIOMUX(63, GPOUT_HIGH, >> + GPOEN_DISABLE, >> + GPI_SYS_TDM_SYNC)>; >> + input-enable; >> + }; >> + >> + tdm0-pins-pcmclk { > > pcmclk-pins { > >> + pinmux = <GPIOMUX(38, GPOUT_HIGH, >> + GPOEN_DISABLE, >> + GPI_SYS_TDM_CLK)>; >> + input-enable; >> + }; >> + }; >> }; >> >> &uart0 { >> @@ -221,3 +255,9 @@ >> pinctrl-0 = <&uart0_pins>; >> status = "okay"; >> }; >> + >> +&tdm { >> + pinctrl-names = "default"; >> + pinctrl-0 = <&tdm0_pins>; > > pinctrl-0 = <&tdm_pins>; > > Best regards, > Hal
OK, I'll update these node's name in the next submit. Thanks.
Best regards, Walker
| |