lkml.org 
[lkml]   [2023]   [Mar]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v1] mtd: rawnand: meson: fix bitmask for length in command word
From
Hello!

@Miquel Raynal, what is the status of this patch?

Thanks, Arseniy

On 23.03.2023 10:57, Arseniy Krasnov wrote:
>
>
> On 22.03.2023 23:10, Martin Blumenstingl wrote:
>> Hello Arseniy,
>>
>> thank you for submitting this fix!
> Thanks!
>>
>> On Wed, Mar 22, 2023 at 7:45 PM Arseniy Krasnov
>> <avkrasnov@sberdevices.ru> wrote:
>>>
>>> Valid mask is 0x3FFF, without this patch the following problems were
>>> found:
>>>
>>> 1) [ 0.938914] Could not find a valid ONFI parameter page, trying
>>> bit-wise majority to recover it
>>> [ 0.947384] ONFI parameter recovery failed, aborting
>>>
>>> 2) Read with disabled ECC mode was broken.
>>>
>>> Fixes: 8fae856c5350 ("mtd: rawnand: meson: add support for Amlogic NAND flash controller")
>>> Signed-off-by: Arseniy Krasnov <AVKrasnov@sberdevices.ru>
>> This matches what I can see in the old vendor driver, so:
> Moreover it was clear that mask of 0x3f is too small for length of data in
> bytes, for example for 2048 + OOB size.
>> Acked-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
>>
>> [...]
>>> - cmd = (len & GENMASK(5, 0)) | scrambler | DMA_DIR(dir);
>>> + cmd = (len & GENMASK(13, 0)) | scrambler | DMA_DIR(dir);
>> My understanding of the vendor driver is that this "len" is only used
>> for "raw" access (my own words: any access that doesn't use the HW ECC
>> engine).
> Exactly, 'len' is only for raw access.
>> As a future improvement (no need to update re-send this patch) it
>> would be great to have a #define with a meaningful name for
>> "GENMASK(13, 0)" (maybe something like NFC_CMD_RAW_LENGTH) as it's
>> used in multiple places now
> Ack
>
> Thanks, Arseniy
>>
>>
>> Best regards,
>> Martin

\
 
 \ /
  Last update: 2023-03-28 18:02    [W:0.109 / U:0.912 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site