lkml.org 
[lkml]   [2023]   [Jan]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 1/3] thermal/drivers/intel: Use generic trip points for quark_dts
From
On 26/01/2023 15:15, Rafael J. Wysocki wrote:
> On Wed, Jan 18, 2023 at 7:16 PM Daniel Lezcano
> <daniel.lezcano@linaro.org> wrote:
>>
>> The thermal framework gives the possibility to register the trip
>> points with the thermal zone. When that is done, no get_trip_* ops are
>> needed and they can be removed.
>>
>> Convert ops content logic into generic trip points and register them with the
>> thermal zone.
>>
>> Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
>> ---

[ ... ]

>> - aux_entry->tzone = thermal_zone_device_register("quark_dts",
>> - QRK_MAX_DTS_TRIPS,
>> - wr_mask,
>> - aux_entry, &tzone_ops, NULL, 0, polling_delay);
>> + err = get_trip_temp(QRK_DTS_ID_TP_CRITICAL, &temperature);
>> + if (err)
>> + goto err_ret;
>> +
>> + aux_entry->trips[QRK_DTS_ID_TP_CRITICAL].temperature = temperature;
>> + aux_entry->trips[QRK_DTS_ID_TP_CRITICAL].type = THERMAL_TRIP_CRITICAL;
>> +
>> + err = get_trip_temp(QRK_DTS_ID_TP_HOT, &temperature);
>> + if (err)
>> + goto err_ret;
>
> If I'm not mistaken, this won't even try to register the thermal zone
> if at least one trip cannot be initialized, but previously it was
> registered in that case, but the trips that failed to respond were
> disabled.
>
> This is a change in behavior that would at least need to be documented
> in the changelog, but it isn't.
>
> I'm not sure if it is safe to make even, however.

Thanks for catching this.

Two solutions:

1. Set the temperature to THERMAL_TEMP_INVALID and change
get_thermal_trip() to return -EINVAL or -ERANGE if the temperature is
THERMAL_TEMP_INVALID

2. Register only the valid trip points.

What would be the preferable way ?


--
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs

Follow Linaro: <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog

\
 
 \ /
  Last update: 2023-03-27 00:03    [W:0.175 / U:0.032 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site