lkml.org 
[lkml]   [2023]   [Jan]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 2/9] ARM: dts: amlogic: Used onboard usb hub reset to enable usb hub
On 18/01/2023 05:44, Anand Moon wrote:
> On Odroid c1 previously use gpio-hog to reset the usb hub,
> switch to used on board usb hub reset to enable the usb hub
> and enable power to usb hub.
>
> Add usb hub regulator as per the schematic.
>
> Signed-off-by: Anand Moon <linux.amoon@gmail.com>
> ---
> v2 - drop the vendor name from compatible string.
> - move the hub node to USB controller node.
> - drop the usb_otg_pwr since it only liked to OTG port
> and link p5v0 to the vdd-supply.
> ---
> arch/arm/boot/dts/meson8b-odroidc1.dts | 24 +++++++++++-------------
> 1 file changed, 11 insertions(+), 13 deletions(-)
>
> diff --git a/arch/arm/boot/dts/meson8b-odroidc1.dts b/arch/arm/boot/dts/meson8b-odroidc1.dts
> index 04356bc639fa..d1f9ce4742a8 100644
> --- a/arch/arm/boot/dts/meson8b-odroidc1.dts
> +++ b/arch/arm/boot/dts/meson8b-odroidc1.dts
> @@ -281,19 +281,6 @@ &gpio_ao {
> "J7 Header Pin 6", "J7 Header Pin 5",
> "J7 Header Pin 7", "HDMI_CEC",
> "SYS_LED", "", "";
> -
> - /*
> - * WARNING: The USB Hub on the Odroid-C1/C1+ needs a reset signal
> - * to be turned high in order to be detected by the USB Controller.
> - * This signal should be handled by a USB specific power sequence
> - * in order to reset the Hub when USB bus is powered down.
> - */
> - usb-hub {
> - gpio-hog;
> - gpios = <GPIOAO_4 GPIO_ACTIVE_HIGH>;
> - output-high;
> - line-name = "usb-hub-reset";
> - };
> };
>
> &ir_receiver {
> @@ -381,5 +368,16 @@ &usb1_phy {
> };
>
> &usb1 {
> + dr_mode = "host";
> + #address-cells = <1>;
> + #size-cells = <0>;
> status = "okay";
> +
> + hub@1 {
> + /* Genesys Logic GL852G usb hub */
> + compatible = "usb5e3,610";
> + reg = <1>;
> + vdd-supply = <&p5v0>;
> + reset-gpio = <&gpio_ao GPIOAO_4 GPIO_ACTIVE_LOW>;
> + };
> };

Reviewed-by: Neil Armstrong <neil.armstrong@linaro.org>

\
 
 \ /
  Last update: 2023-03-26 23:45    [W:0.024 / U:0.504 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site