lkml.org 
[lkml]   [2021]   [Dec]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v2 0/6] Support Spi in i2c-multi-instantiate driver
From
Hi Stefan,

On 12/10/21 16:40, Stefan Binding wrote:
> Add support for SPI bus in the ic2-multi-instantiate driver as
> upcoming laptops will need to multi instantiate SPI devices from
> a single device node, which has multiple SpiSerialBus entries at
> the ACPI table.
>
> With the new SPI support, i2c-multi-instantiate becomes
> bus-multi-instantiate and is moved to the ACPI folder.
>
> The intention is to support the SPI bus by re-using the current
> I2C multi instantiate, instead of creating a new SPI multi
> instantiate, to make it possible for peripherals that can be
> controlled by I2C or SPI to have the same HID at the ACPI table.
>
> The new driver (Bus multi instantiate, bmi) checks for the
> hard-coded bus type and returns -ENODEV in case of zero devices
> found for that bus. In the case of automatic bus detection,
> the driver will give preference to I2C.
>
> The expectation is for a device node in the ACPI table to have
> multiple I2cSerialBus only or multiple SpiSerialBus only, not
> a mix of both; and for the case where there are both entries in
> one device node, only the I2C ones would be probed.
>
> This new bus multi instantiate will be used in CS35L41 HDA new
> driver, being upstreamed:
> https://lkml.org/lkml/2021/11/23/723

Unfortunately you never really answered my questions about v1
of this series:

https://lore.kernel.org/platform-driver-x86/a1f546c2-5c63-573a-c032-603c792f3f7c@redhat.com/

So looking at the linked CS35L41 HDA series there is a single
ACPI device node with a HID of CLSA0100 which describes
two CS35L41 amplifiers connected over I2C ?

I assume you are doing this work because there are also designs
where there is a similar CLSA0100 ACPI device which also describes
two CS35L41 amplifiers but then connected over SPI ?

It would really help if you can:

1. Answer my questions from v1
2. Provide a concrete example of a device where these changes will
be necessary to make things work, preferably with a link to an
actual ACPI DSDT of that device.

Until you can better clarify why this is necessary, this series
gets a nack from me. The i2c-mult-instantiate code is a hack to
deal with some rather sub-optimal choices made in DSDTs used on
devices shipped with Windows and unless absolutely necessary
I would rather not see this get expanded to SPI.

Regards,

Hans

\
 
 \ /
  Last update: 2021-12-10 17:55    [W:0.118 / U:0.324 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site