lkml.org 
[lkml]   [2020]   [Aug]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/2] mm/rmap: Fixup copying of soft dirty and uffd ptes
On Mon, Aug 24, 2020 at 06:31:28PM +1000, Alistair Popple wrote:
> During memory migration a pte is temporarily replaced with a migration
> swap pte. Some pte bits from the existing mapping such as the soft-dirty
> and uffd write-protect bits are preserved by copying these to the
> temporary migration swap pte.
>
> However these bits are not stored at the same location for swap and
> non-swap ptes. Therefore testing these bits requires using the
> appropriate helper function for the given pte type.
>
> Unfortunately several code locations were found where the wrong helper
> function is being used to test soft_dirty and uffd_wp bits which leads
> to them getting incorrectly set or cleared during page-migration.
>
> Fix these by using the correct tests based on pte type.
>
> Fixes: a5430dda8a3a ("mm/migrate: support un-addressable ZONE_DEVICE page in migration")
> Fixes: 8c3328f1f36a ("mm/migrate: migrate_vma() unmap page from vma while collecting pages")
> Fixes: f45ec5ff16a7 ("userfaultfd: wp: support swap and page migration")
> Signed-off-by: Alistair Popple <alistair@popple.id.au>
> Cc: stable@vger.kernel.org
> ---
> mm/migrate.c | 6 ++++--
> mm/rmap.c | 9 +++++++--
> 2 files changed, 11 insertions(+), 4 deletions(-)
>
> diff --git a/mm/migrate.c b/mm/migrate.c
> index ddb64253fe3e..5bea19c496af 100644
> --- a/mm/migrate.c
> +++ b/mm/migrate.c
> @@ -2427,9 +2427,11 @@ static int migrate_vma_collect_pmd(pmd_t *pmdp,
> entry = make_migration_entry(page, mpfn &
> MIGRATE_PFN_WRITE);
> swp_pte = swp_entry_to_pte(entry);
> - if (pte_soft_dirty(pte))
> + if ((is_swap_pte(pte) && pte_swp_soft_dirty(pte))
> + || (!is_swap_pte(pte) && pte_soft_dirty(pte)))
> swp_pte = pte_swp_mksoft_dirty(swp_pte);
> - if (pte_uffd_wp(pte))
> + if ((is_swap_pte(pte) && pte_swp_uffd_wp(pte))
> + || (!is_swap_pte(pte) && pte_uffd_wp(pte)))
> swp_pte = pte_swp_mkuffd_wp(swp_pte);
> set_pte_at(mm, addr, ptep, swp_pte);

The worst case is we'll call is_swap_pte() four times for each entry. Also
considering we know it's not a pte_none() when reach here, how about:

if (pte_present(pte)) {
// pte handling of both soft dirty and uffd-wp
} else {
// swap handling of both soft dirty and uffd-wp
}

?

Thanks,

--
Peter Xu

\
 
 \ /
  Last update: 2020-08-24 17:45    [W:0.035 / U:0.052 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site