lkml.org 
[lkml]   [2020]   [Aug]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 3/5] arm64: dts: imx8mq-phanbell: Replace deprecated phy reset properties
Date
Use preferred properties of phy node instead of deprecated
phy-reset-gpios (and others). This avoids copying deprecated code into
future DTSes.

Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>

---

Not tested on HW.
---
arch/arm64/boot/dts/freescale/imx8mq-phanbell.dts | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8mq-phanbell.dts b/arch/arm64/boot/dts/freescale/imx8mq-phanbell.dts
index 77ab568fae67..3f541ddf0768 100644
--- a/arch/arm64/boot/dts/freescale/imx8mq-phanbell.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mq-phanbell.dts
@@ -262,9 +262,6 @@
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_fec1>;
phy-mode = "rgmii-id";
- phy-reset-gpios = <&gpio1 9 GPIO_ACTIVE_LOW>;
- phy-reset-duration = <10>;
- phy-reset-post-delay = <50>;
phy-handle = <&ethphy0>;
fsl,magic-packet;
status = "okay";
@@ -275,6 +272,9 @@
ethphy0: ethernet-phy@0 {
compatible = "ethernet-phy-ieee802.3-c22";
reg = <0>;
+ reset-gpios = <&gpio1 9 GPIO_ACTIVE_LOW>;
+ reset-assert-us = <10000>;
+ reset-deassert-us = <50000>;
};
};
};
--
2.17.1
\
 
 \ /
  Last update: 2020-08-23 13:16    [W:0.079 / U:0.252 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site