lkml.org 
[lkml]   [2020]   [Dec]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/2] mtd: nand: ecc-bch: Fix the size of calc_buf/code_buf of the BCH
Date
If eccbyte exceeds 64 bytes, the read operation will get wrong results.
For example: Flash with a page size of 4096 bytes (eccbyte: 104 bytes).
During the read operation, after executing nand_ecc_sw_bch_calculate(),
since the calc_buf/code_buf ranges overlap each other, the last three
steps of ecc_code (read from oob) will be changed.

The root cause is that the size of calc_buf/code_buf is limited to 64
bytes, although sizeof(mtd->oobsize) returns 4, kzalloc() will allocate
64 bytes (cache size alignment).

So we correct the size of calc_buf/code_buf to mtd->oobsize.

Signed-off-by: YouChing Lin <ycllin@mxic.com.tw>
---
drivers/mtd/nand/ecc-sw-bch.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/mtd/nand/ecc-sw-bch.c b/drivers/mtd/nand/ecc-sw-bch.c
index 4d8a979..0a0ac11 100644
--- a/drivers/mtd/nand/ecc-sw-bch.c
+++ b/drivers/mtd/nand/ecc-sw-bch.c
@@ -237,8 +237,8 @@ int nand_ecc_sw_bch_init_ctx(struct nand_device *nand)

engine_conf->code_size = code_size;
engine_conf->nsteps = nsteps;
- engine_conf->calc_buf = kzalloc(sizeof(mtd->oobsize), GFP_KERNEL);
- engine_conf->code_buf = kzalloc(sizeof(mtd->oobsize), GFP_KERNEL);
+ engine_conf->calc_buf = kzalloc(mtd->oobsize, GFP_KERNEL);
+ engine_conf->code_buf = kzalloc(mtd->oobsize, GFP_KERNEL);
if (!engine_conf->calc_buf || !engine_conf->code_buf) {
ret = -ENOMEM;
goto free_bufs;
--
1.9.1
\
 
 \ /
  Last update: 2020-12-10 04:54    [W:0.061 / U:0.424 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site