lkml.org 
[lkml]   [2018]   [Jul]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v10 4/7] i2c: fsi: Add abort and hardware reset procedures
Eddie,

> Thanks for the details. I have sent up a new series which will only do the
> bus reset if SDA is low. With our current hardware configuration, this

Thanks.

> *should* be sufficient to recover all the possible errors. However, there
> are configurations where it will not be enough, in which case getting the
> data line stuck high or clock line stuck either high or low can occur,
> necessitating the full reset. But since I can't demonstrate those at the
> moment, I can't argue to include that now :)

For the record, I am *really* interested in these cases. Just from
reading the above I wonder how SDA can stuck high when being open drain,
and how you will create 9 SCL pulses if SCL is stuck low. But if we have
a test case, we will figure out something together.

Thanks,

Wolfram

[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2018-07-06 00:06    [W:0.069 / U:1.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site