Messages in this thread | | | From | Andy Shevchenko <> | Date | Wed, 4 Jul 2018 01:54:48 +0300 | Subject | Re: [PATCH v2 2/2] IIO: st_accel_i2c.c: Use probe_new() instead of probe() |
| |
On Tue, Jul 3, 2018 at 9:06 AM, Nikolaus Voss <nikolaus.voss@loewensteinmedical.de> wrote: > struct i2c_device_id argument of probe() is not used, so use probe_new() > instead. >
This makes...
> MODULE_DEVICE_TABLE(i2c, st_accel_id_table);
...this table obsolete IIUC. At least that's what I did when switched to ->probe_new() in some drivers.
If I'm mistaken (again? :-) ) I would hear from someone to point me how it can be used after a switch.
> > -static int st_accel_i2c_probe(struct i2c_client *client, > - const struct i2c_device_id *id) > +static int st_accel_i2c_probe(struct i2c_client *client) > { > struct iio_dev *indio_dev; > struct st_sensor_data *adata; > @@ -182,7 +181,7 @@ static struct i2c_driver st_accel_driver = { > .of_match_table = of_match_ptr(st_accel_of_match), > .acpi_match_table = ACPI_PTR(st_accel_acpi_match), > }, > - .probe = st_accel_i2c_probe, > + .probe_new = st_accel_i2c_probe, > .remove = st_accel_i2c_remove, > .id_table = st_accel_id_table, > }; > -- > 2.17.1 >
-- With Best Regards, Andy Shevchenko
| |