Messages in this thread | | | Date | Mon, 16 Jul 2018 23:16:40 -0700 | From | Tony Lindgren <> | Subject | Re: [PATCH v4 2/2] ARM: dts: am335x: add am335x-sancloud-bbe board support |
| |
Hi Koen,
Just noticed there should be generic node names here too, see below.
* Koen Kooi <koen@dominion.thruhere.net> [180713 06:28]: > The "Beaglebone Enhanced" by Sancloud is based on the Beaglebone Black, > but with the following differences: > > * Gigabit capable PHY > * Extra USB hub, optional i2c control > * lps3331ap barometer connected over i2c > * MPU6050 6 axis MEMS accelerometer/gyro connected over i2c > * 1GiB DDR3 RAM > * RTL8723 Wifi/Bluetooth connected over USB
> +&i2c0 { > + lps331ap: lps331ap@5C { > + compatible = "st,lps331ap-press"; > + st,drdy-int-pin = <1>; > + reg = <0x5C>; > + interrupt-parent = <&gpio1>; > + interrupts = <26 IRQ_TYPE_EDGE_RISING>; > + };
lps33lap: barometer@5c
> + mpu6050: mpu6050@68 { > + compatible = "invensense,mpu6050"; > + reg = <0x68>; > + interrupt-parent = <&gpio0>; > + interrupts = <2 IRQ_TYPE_EDGE_RISING>; > + orientation = <0xff 0 0 0 1 0 0 0 0xff>; > + };
mpu6050: accelerometer@2c
And so on. Please check the lower case hex numbers too as that's what Linux typically uses.
Thanks,
Tony
| |