lkml.org 
[lkml]   [2018]   [Jun]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 4/5] dmaengine: xilinx_dma: autodetect whether the HW supports scatter-gather
Date
The AXIDMA and CDMA HW can be either direct-access or scatter-gather
version. These are SW incompatible.

The driver can handle both version: a DT property was used to
tell the driver whether to assume the HW is is scatter-gather mode.

This patch makes the driver to autodetect this information. The DT
property is not required anymore.

No changes for VDMA.

Cc: Rob Herring <robh+dt@kernel.org>
Cc: Mark Rutland <mark.rutland@arm.com>
Cc: devicetree@vger.kernel.org
Cc: Radhey Shyam Pandey <radhey.shyam.pandey@xilinx.com>
Signed-off-by: Andrea Merello <andrea.merello@gmail.com>
Reviewed-by: Radhey Shyam Pandey <radhey.shyam.pandey@xilinx.com>
---
Changes in v2:
- autodetect only in !VDMA case
Changes in v3:
- cc DT maintainers/ML
---
drivers/dma/xilinx/xilinx_dma.c | 14 ++++++++++----
1 file changed, 10 insertions(+), 4 deletions(-)

diff --git a/drivers/dma/xilinx/xilinx_dma.c b/drivers/dma/xilinx/xilinx_dma.c
index 7f0ab904b749..43fcc71ff287 100644
--- a/drivers/dma/xilinx/xilinx_dma.c
+++ b/drivers/dma/xilinx/xilinx_dma.c
@@ -86,6 +86,7 @@
#define XILINX_DMA_DMASR_DMA_DEC_ERR BIT(6)
#define XILINX_DMA_DMASR_DMA_SLAVE_ERR BIT(5)
#define XILINX_DMA_DMASR_DMA_INT_ERR BIT(4)
+#define XILINX_DMA_DMASR_SG_MASK BIT(3)
#define XILINX_DMA_DMASR_IDLE BIT(1)
#define XILINX_DMA_DMASR_HALTED BIT(0)
#define XILINX_DMA_DMASR_DELAY_MASK GENMASK(31, 24)
@@ -406,7 +407,6 @@ struct xilinx_dma_config {
* @dev: Device Structure
* @common: DMA device structure
* @chan: Driver specific DMA channel
- * @has_sg: Specifies whether Scatter-Gather is present or not
* @mcdma: Specifies whether Multi-Channel is present or not
* @flush_on_fsync: Flush on frame sync
* @ext_addr: Indicates 64 bit addressing is supported by dma device
@@ -426,7 +426,6 @@ struct xilinx_dma_device {
struct device *dev;
struct dma_device common;
struct xilinx_dma_chan *chan[XILINX_DMA_MAX_CHANS_PER_DEVICE];
- bool has_sg;
bool mcdma;
u32 flush_on_fsync;
bool ext_addr;
@@ -2393,7 +2392,6 @@ static int xilinx_dma_chan_probe(struct xilinx_dma_device *xdev,

chan->dev = xdev->dev;
chan->xdev = xdev;
- chan->has_sg = xdev->has_sg;
chan->desc_pendingcount = 0x0;
chan->ext_addr = xdev->ext_addr;
/* This variable ensures that descriptors are not
@@ -2486,6 +2484,15 @@ static int xilinx_dma_chan_probe(struct xilinx_dma_device *xdev,
chan->stop_transfer = xilinx_dma_stop_transfer;
}

+ /* check if SG is enabled (only for AXIDMA and CDMA) */
+ if (xdev->dma_config->dmatype != XDMA_TYPE_VDMA) {
+ if (dma_ctrl_read(chan, XILINX_DMA_REG_DMASR) &
+ XILINX_DMA_DMASR_SG_MASK)
+ chan->has_sg = true;
+ dev_dbg(chan->dev, "ch %d: SG %s\n", chan->id,
+ chan->has_sg ? "enabled" : "disabled");
+ }
+
/* Initialize the tasklet */
tasklet_init(&chan->tasklet, xilinx_dma_do_tasklet,
(unsigned long)chan);
@@ -2624,7 +2631,6 @@ static int xilinx_dma_probe(struct platform_device *pdev)
return PTR_ERR(xdev->regs);

/* Retrieve the DMA engine properties from the device tree */
- xdev->has_sg = of_property_read_bool(node, "xlnx,include-sg");
xdev->max_buffer_len = GENMASK(XILINX_DMA_MAX_TRANS_LEN_MAX - 1, 0);

if (xdev->dma_config->dmatype == XDMA_TYPE_AXIDMA) {
--
2.17.1
\
 
 \ /
  Last update: 2018-06-25 11:28    [W:0.073 / U:2.680 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site