lkml.org 
[lkml]   [2018]   [Jun]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] arch/x86/entry/vsyscall/vsyscall_gtod.c: remove __read_mostly from vclocks_used
On Fri, 22 Jun 2018, Andy Lutomirski wrote:
> On Fri, Jun 22, 2018 at 3:47 PM Thomas Gleixner <tglx@linutronix.de> wrote:
> > On Mon, 4 Jun 2018, Michael Rodin wrote:
> >
> > > The variable "vclocks_used" doesn't appear to be "read mostly".
> > > Measurements of the access frequency with perf stat [1] and
> > > perf report show, that approximately half of the accesses to
> > > this variable are write accesses and happen in update_vsyscall()
> > > in the file arch/x86/entry/vsyscall/vsyscall_gtod.c.
> > > The measurements were done with the kernel 4.13.0-43-generic used by
> > > ubuntu as well as with the stable kernel 4.16.7 with a custom config.
> > > I've used "perf bench sched" and iperf3 as workloads.
> > >
> > > This was discovered during my master thesis in the CADOS project [2].
> >
> > Nice find, but ...
> >
> > The point is that the content of that variable changes once in a blue moon,
> > so the intent of marking it read_mostly is almost correct.
>
> I would propose a rather different fix. Add a an
> arch_change_clocksource() function. Do:
>
> static inline void arch_change_clocksource(struct clocksource
> *new_clocksource) { ... }
> #define arch_change_clocksource arch_change_clocksource
>
> and
>
> #ifndef arch_change_clocksource
> static inline void arch_change_clocksource(struct clocksource
> *new_clocksource) {}
> #endif
>
> in the generic header. In change_clocksource(), add a call to
> arch_change_clocksource() right after tk_setup_internals(). In x86's
> arch_change_clocksource, update vclocks_used.
>
> Now it's genuinely read_mostly, and we don't need to touch that
> cacheline at all in the normal clock tick code. Everyone wins.
> (vclocks_used is actually rather rarely read. It's only used to
> prevent user code from accessing a never-used clocksource through the
> vvar area, which is a hardening measure. It's only referenced from
> the vvar fault handler code.)

Agreed.

Thanks,

tglx

\
 
 \ /
  Last update: 2018-06-23 11:05    [W:0.046 / U:0.152 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site