Messages in this thread | | | Subject | Re: [PATCH 7/7] tty: serial: lantiq: Add CCF support | From | "Wu, Songjun" <> | Date | Thu, 14 Jun 2018 14:38:06 +0800 |
| |
On 6/13/2018 6:39 AM, Rob Herring wrote: > On Tue, Jun 12, 2018 at 01:40:34PM +0800, Songjun Wu wrote: >> Previous implementation uses platform-dependent API to get the clock. >> Those functions are not available for other SoC which uses the same IP. >> The CCF (Common Clock Framework) have an abstraction based APIs >> for clock. >> Change to use CCF APIs to get clock and rate. >> So that different SoCs can use the same driver. >> Clocks and clock-names are updated in device tree binding. >> >> Signed-off-by: Songjun Wu <songjun.wu@linux.intel.com> >> >> --- >> >> .../devicetree/bindings/serial/lantiq_asc.txt | 15 +++ > Please split bindings to separate patch. Thanks. It will be split to two separate patches, one for bindings, the other for code. >> drivers/tty/serial/Kconfig | 2 +- >> drivers/tty/serial/lantiq.c | 101 +++++++++++++++++---- >> 3 files changed, 98 insertions(+), 20 deletions(-) >> >> diff --git a/Documentation/devicetree/bindings/serial/lantiq_asc.txt b/Documentation/devicetree/bindings/serial/lantiq_asc.txt >> index 3acbd309ab9d..608f0c87a4af 100644 >> --- a/Documentation/devicetree/bindings/serial/lantiq_asc.txt >> +++ b/Documentation/devicetree/bindings/serial/lantiq_asc.txt >> @@ -6,6 +6,10 @@ Required properties: >> - interrupts: the 3 (tx rx err) interrupt numbers. The interrupt specifier >> depends on the interrupt-parent interrupt controller. >> >> +Optional properties: >> +- clocks: Should contain frequency clock and gate clock >> +- clock-names: Should be "freq" and "asc" >> + >> Example: >> >> asc1: serial@e100c00 { >> @@ -14,3 +18,14 @@ asc1: serial@e100c00 { >> interrupt-parent = <&icu0>; >> interrupts = <112 113 114>; >> }; >> + >> +asc0: serial@600000 { >> + compatible = "lantiq,asc"; >> + reg = <0x600000 0x100000>; > 1MB of address space? That wastes a lot of virtual space on 32-bit > systems. Just make the size the actual used range. The size of address space will be updated to the actual used range. >> + interrupt-parent = <&gic>; >> + interrupts = <GIC_SHARED 103 IRQ_TYPE_LEVEL_HIGH>, >> + <GIC_SHARED 105 IRQ_TYPE_LEVEL_HIGH>, >> + <GIC_SHARED 106 IRQ_TYPE_LEVEL_HIGH>; >> + clocks = <&pll0aclk SSX4_CLK>, <&clkgate1 GATE_URT_CLK>; >> + clock-names = "freq", "asc"; >> +};
| |