lkml.org 
[lkml]   [2018]   [Jun]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/6] PCI: iproc: Add INTx support with better modeling
On 2018-05-30 03:28, Ray Jui wrote:
> Add PCIe legacy interrupt INTx support to the iProc PCIe driver by
> modeling it with its own IRQ domain. All 4 interrupts INTA, INTB, INTC,
> INTD share the same interrupt line connected to the GIC in the system,
> while the status of each INTx can be obtained through the INTX CSR
> register
>
> Signed-off-by: Ray Jui <ray.jui@broadcom.com>
> ---
> drivers/pci/host/pcie-iproc-platform.c | 2 +
> drivers/pci/host/pcie-iproc.c | 95
> +++++++++++++++++++++++++++++++++-
> drivers/pci/host/pcie-iproc.h | 6 +++
> 3 files changed, 101 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/pci/host/pcie-iproc-platform.c
> b/drivers/pci/host/pcie-iproc-platform.c
> index e764a2a..7a51e6c 100644
> --- a/drivers/pci/host/pcie-iproc-platform.c
> +++ b/drivers/pci/host/pcie-iproc-platform.c
> @@ -70,6 +70,8 @@ static int iproc_pcie_pltfm_probe(struct
> platform_device *pdev)
> }
> pcie->base_addr = reg.start;
>
> + pcie->irq = platform_get_irq(pdev, 0);
> +
> if (of_property_read_bool(np, "brcm,pcie-ob")) {
> u32 val;
>
> diff --git a/drivers/pci/host/pcie-iproc.c
> b/drivers/pci/host/pcie-iproc.c
> index 14f374d..0bd2c14 100644
> --- a/drivers/pci/host/pcie-iproc.c
> +++ b/drivers/pci/host/pcie-iproc.c
> @@ -14,6 +14,7 @@
> #include <linux/delay.h>
> #include <linux/interrupt.h>
> #include <linux/irqchip/arm-gic-v3.h>
> +#include <linux/irqchip/chained_irq.h>
> #include <linux/platform_device.h>
> #include <linux/of_address.h>
> #include <linux/of_pci.h>
> @@ -264,6 +265,7 @@ enum iproc_pcie_reg {
>
> /* enable INTx */
> IPROC_PCIE_INTX_EN,
> + IPROC_PCIE_INTX_CSR,
>
> /* outbound address mapping */
> IPROC_PCIE_OARR0,
> @@ -305,6 +307,7 @@ static const u16 iproc_pcie_reg_paxb_bcma[] = {
> [IPROC_PCIE_CFG_ADDR] = 0x1f8,
> [IPROC_PCIE_CFG_DATA] = 0x1fc,
> [IPROC_PCIE_INTX_EN] = 0x330,
> + [IPROC_PCIE_INTX_CSR] = 0x334,
> [IPROC_PCIE_LINK_STATUS] = 0xf0c,
> };
>
> @@ -316,6 +319,7 @@ static const u16 iproc_pcie_reg_paxb[] = {
> [IPROC_PCIE_CFG_ADDR] = 0x1f8,
> [IPROC_PCIE_CFG_DATA] = 0x1fc,
> [IPROC_PCIE_INTX_EN] = 0x330,
> + [IPROC_PCIE_INTX_CSR] = 0x334,
> [IPROC_PCIE_OARR0] = 0xd20,
> [IPROC_PCIE_OMAP0] = 0xd40,
> [IPROC_PCIE_OARR1] = 0xd28,
> @@ -332,6 +336,7 @@ static const u16 iproc_pcie_reg_paxb_v2[] = {
> [IPROC_PCIE_CFG_ADDR] = 0x1f8,
> [IPROC_PCIE_CFG_DATA] = 0x1fc,
> [IPROC_PCIE_INTX_EN] = 0x330,
> + [IPROC_PCIE_INTX_CSR] = 0x334,
> [IPROC_PCIE_OARR0] = 0xd20,
> [IPROC_PCIE_OMAP0] = 0xd40,
> [IPROC_PCIE_OARR1] = 0xd28,
> @@ -782,9 +787,90 @@ static int iproc_pcie_check_link(struct iproc_pcie
> *pcie)
> return link_is_active ? 0 : -ENODEV;
> }
>
> -static void iproc_pcie_enable(struct iproc_pcie *pcie)
> +static int iproc_pcie_intx_map(struct irq_domain *domain, unsigned int
> irq,
> + irq_hw_number_t hwirq)
> {
> + irq_set_chip_and_handler(irq, &dummy_irq_chip, handle_simple_irq);
> + irq_set_chip_data(irq, domain->host_data);
> +
> + return 0;
> +}
> +
> +static const struct irq_domain_ops intx_domain_ops = {
> + .map = iproc_pcie_intx_map,
> +};
> +
> +static void iproc_pcie_isr(struct irq_desc *desc)
> +{
> + struct irq_chip *chip = irq_desc_get_chip(desc);
> + struct iproc_pcie *pcie;
> + struct device *dev;
> + unsigned long status;
> + u32 bit, virq;
> +
> + chained_irq_enter(chip, desc);
> + pcie = irq_desc_get_handler_data(desc);
> + dev = pcie->dev;
> +
> + /* go through INTx A, B, C, D until all interrupts are handled */
> + while ((status = iproc_pcie_read_reg(pcie, IPROC_PCIE_INTX_CSR) &
> + SYS_RC_INTX_MASK) != 0) {
> + for_each_set_bit(bit, &status, PCI_NUM_INTX) {
> + virq = irq_find_mapping(pcie->irq_domain, bit + 1);
> + if (virq)
> + generic_handle_irq(virq);
> + else
> + dev_err(dev, "unexpected INTx%u\n", bit);
> + }
> + }
> +

Are these level or edge interrupts ? although I see DT says:
IRQ_TYPE_NONE
do you not need to clear interrupt status bits in IPROC_PCIE_INTX_CSR ?

> + chained_irq_exit(chip, desc);
> +}
> +
> +static int iproc_pcie_intx_enable(struct iproc_pcie *pcie)
> +{
> + struct device *dev = pcie->dev;
> + struct device_node *node = dev->of_node;
> + int ret;
> +
> iproc_pcie_write_reg(pcie, IPROC_PCIE_INTX_EN, SYS_RC_INTX_MASK);
> +
> + /*
> + * BCMA devices do not map INTx the same way as platform devices. All
> + * BCMA needs is the above code to enable INTx
> + */
> + if (pcie->irq <= 0)
> + return 0;
> +
> + /* set IRQ handler */
> + irq_set_chained_handler_and_data(pcie->irq, iproc_pcie_isr, pcie);
> +
> + /* add IRQ domain for INTx */
> + pcie->irq_domain = irq_domain_add_linear(node, PCI_NUM_INTX + 1,
> + &intx_domain_ops, pcie);
> + if (!pcie->irq_domain) {
> + dev_err(dev, "failed to add INTx IRQ domain\n");
> + ret = -ENOMEM;
> + goto err_rm_handler_data;
> + }
> +
> + return 0;
> +
> +err_rm_handler_data:
> + irq_set_chained_handler_and_data(pcie->irq, NULL, NULL);
> +
> + return ret;
> +}
> +
> +static void iproc_pcie_intx_disable(struct iproc_pcie *pcie)
> +{
> + iproc_pcie_write_reg(pcie, IPROC_PCIE_INTX_EN, 0x0);
> +
> + if (pcie->irq <= 0)
> + return;
> +
> + irq_domain_remove(pcie->irq_domain);
> + irq_set_chained_handler_and_data(pcie->irq, NULL, NULL);
> }
>
> static inline bool iproc_pcie_ob_is_valid(struct iproc_pcie *pcie,
> @@ -1410,7 +1496,11 @@ int iproc_pcie_setup(struct iproc_pcie *pcie,
> struct list_head *res)
> goto err_power_off_phy;
> }
>
> - iproc_pcie_enable(pcie);
> + ret = iproc_pcie_intx_enable(pcie);
> + if (ret) {
> + dev_err(dev, "failed to enable INTx\n");
> + goto err_power_off_phy;
> + }
>
> if (IS_ENABLED(CONFIG_PCI_MSI))
> if (iproc_pcie_msi_enable(pcie))
> @@ -1455,6 +1545,7 @@ int iproc_pcie_remove(struct iproc_pcie *pcie)
> pci_remove_root_bus(pcie->root_bus);
>
> iproc_pcie_msi_disable(pcie);
> + iproc_pcie_intx_disable(pcie);
>
> phy_power_off(pcie->phy);
> phy_exit(pcie->phy);
> diff --git a/drivers/pci/host/pcie-iproc.h
> b/drivers/pci/host/pcie-iproc.h
> index 67081cb..cbcaf9d 100644
> --- a/drivers/pci/host/pcie-iproc.h
> +++ b/drivers/pci/host/pcie-iproc.h
> @@ -72,6 +72,9 @@ struct iproc_msi;
> * @ib: inbound mapping related parameters
> * @ib_map: outbound mapping region related parameters
> *
> + * @irq: interrupt line wired to the generic GIC for INTx
> + * @irq_domain: IRQ domain for INTx
> + *
> * @need_msi_steer: indicates additional configuration of the iProc
> PCIe
> * controller is required to steer MSI writes to external interrupt
> controller
> * @msi: MSI data
> @@ -99,6 +102,9 @@ struct iproc_pcie {
> struct iproc_pcie_ib ib;
> const struct iproc_pcie_ib_map *ib_map;
>
> + int irq;
> + struct irq_domain *irq_domain;
> +
> bool need_msi_steer;
> struct iproc_msi *msi;
> };

\
 
 \ /
  Last update: 2018-06-12 10:53    [W:0.072 / U:4.136 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site