lkml.org 
[lkml]   [2018]   [May]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [RFC PATCH 3/5] net: macb: Add pm runtime support
Hi Claudiu,

On Thu, May 3, 2018 at 3:39 PM, Claudiu Beznea
<Claudiu.Beznea@microchip.com> wrote:
>
>
> On 22.03.2018 15:51, harinikatakamlinux@gmail.com wrote:
>> From: Harini Katakam <harinik@xilinx.com>
<snip>
> I would use a "goto" instruction, e.g.:
> value = -ETIMEDOUT;
> goto out;
>

Will do

>
> Below, in macb_open() you have a return err; case:
> err = macb_alloc_consistent(bp);
> if (err) {
> netdev_err(dev, "Unable to allocate DMA memory (error %d)\n",
> err);
> return err;
> }
>
> You have to undo pm_runtime_get_sync() with pm_runtime_put_sync() or something
> similar to decrement dev->power.usage_count.

Will do

<snip>
>> @@ -4104,11 +4145,16 @@ static int macb_remove(struct platform_device *pdev)
>> mdiobus_free(bp->mii_bus);
>>
>> unregister_netdev(dev);
>> - clk_disable_unprepare(bp->tx_clk);
>> - clk_disable_unprepare(bp->hclk);
>> - clk_disable_unprepare(bp->pclk);
>> - clk_disable_unprepare(bp->rx_clk);
>> - clk_disable_unprepare(bp->tsu_clk);
>> + pm_runtime_disable(&pdev->dev);
>> + pm_runtime_dont_use_autosuspend(&pdev->dev);
>> + if (!pm_runtime_suspended(&pdev->dev)) {
>> + clk_disable_unprepare(bp->tx_clk);
>> + clk_disable_unprepare(bp->hclk);
>> + clk_disable_unprepare(bp->pclk);
>> + clk_disable_unprepare(bp->rx_clk);
>> + clk_disable_unprepare(bp->tsu_clk);
>> + pm_runtime_set_suspended(&pdev->dev);
>
> This is driver remove function. Shouldn't clocks be removed?

clk_disable_unprepare IS being done here.
The check for !pm_runtime_suspended is just to make sure the
clocks are not already removed (in runtime_suspend).

Regards,
Harini

\
 
 \ /
  Last update: 2018-05-03 13:13    [W:0.924 / U:0.032 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site