lkml.org 
[lkml]   [2018]   [May]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH V0:net-next 2/4] dt-bindings: stm32-dwmac: add support of MPU families
Date
Add description for Ethernet MPU families fields

Signed-off-by: Christophe Roullier <christophe.roullier@st.com>
Reviewed-by: Rob Herring <robh@kernel.org>
---
Documentation/devicetree/bindings/net/stm32-dwmac.txt | 18 ++++++++++++++++--
1 file changed, 16 insertions(+), 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/net/stm32-dwmac.txt b/Documentation/devicetree/bindings/net/stm32-dwmac.txt
index 489dbcb..1341012 100644
--- a/Documentation/devicetree/bindings/net/stm32-dwmac.txt
+++ b/Documentation/devicetree/bindings/net/stm32-dwmac.txt
@@ -6,14 +6,28 @@ Please see stmmac.txt for the other unchanged properties.
The device node has following properties.

Required properties:
-- compatible: Should be "st,stm32-dwmac" to select glue, and
+- compatible: For MCU family should be "st,stm32-dwmac" to select glue, and
"snps,dwmac-3.50a" to select IP version.
+ For MPU family should be "st,stm32mp1-dwmac" to select
+ glue, and "snps,dwmac-4.20a" to select IP version.
- clocks: Must contain a phandle for each entry in clock-names.
- clock-names: Should be "stmmaceth" for the host clock.
Should be "mac-clk-tx" for the MAC TX clock.
Should be "mac-clk-rx" for the MAC RX clock.
+ For MPU family need to add also "ethstp" for power mode clock and,
+ "syscfg-clk" for SYSCFG clock.
+- interrupt-names: Should contain a list of interrupt names corresponding to
+ the interrupts in the interrupts property, if available.
+ Should be "macirq" for the main MAC IRQ
+ Should be "eth_wake_irq" for the IT which wake up system
- st,syscon : Should be phandle/offset pair. The phandle to the syscon node which
- encompases the glue register, and the offset of the control register.
+ encompases the glue register, and the offset of the control register.
+
+Optional properties:
+- clock-names: For MPU family "mac-clk-ck" for PHY without quartz
+- st,int-phyclk (boolean) : valid only where PHY do not have quartz and need to be clock
+ by RCC
+
Example:

ethernet@40028000 {
--
1.9.1
\
 
 \ /
  Last update: 2018-05-25 09:49    [W:0.037 / U:0.640 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site