lkml.org 
[lkml]   [2018]   [May]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 3/6] block: Create scsi_sense.h for SCSI and ATAPI
From
Date
On 5/22/18 5:49 PM, Kees Cook wrote:
> On Tue, May 22, 2018 at 4:42 PM, Jens Axboe <axboe@kernel.dk> wrote:
>> On May 22, 2018, at 5:31 PM, Kees Cook <keescook@chromium.org> wrote:
>>>
>>>> On Tue, May 22, 2018 at 12:16 PM, Jens Axboe <axboe@kernel.dk> wrote:
>>>>> On 5/22/18 1:13 PM, Christoph Hellwig wrote:
>>>>>> On Tue, May 22, 2018 at 01:09:41PM -0600, Jens Axboe wrote:
>>>>>> I think Martin and Christoph are objecting to moving the code to
>>>>>> block/scsi_ioctl.h. I don't care too much about where the code is, but
>>>>>> think it would be nice to have the definitions in a separate header. But
>>>>>> if they prefer just pulling in all of SCSI for it, well then I guess
>>>>>> it's pointless to move the header bits. Seems very heavy handed to me,
>>>>>> though.
>>>>>
>>>>> It might be heavy handed for the 3 remaining users of drivers/ide,
>>>>
>>>> Brutal :-)
>>>
>>> Heh. I noticed a similar sense buffer use in drivers/cdrom/cdrom.c
>>> too. Is this okay under the same considerations?
>>
>> This is going from somewhat crazy to pretty nuts, imho. I guess in practical terms it doesn’t matter that much, since most folks would be using sr. I still think a split would be vastly superior. Just keep the scsi code in drivers/scsi/ and make it independently selectable.
>
> I had originally tied it to BLK_SCSI_REQUEST. Logically speaking,
> sense buffers are part of the request, and the CONFIG work is already
> done. This is roughly what I tried to do before, since scsi_ioctl.c is
> the only code pulled in for CONFIG_BLK_SCSI_REQUEST:
>
> $ git grep BLK_SCSI_REQUEST | grep Makefile
> block/Makefile:obj-$(CONFIG_BLK_SCSI_REQUEST) += scsi_ioctl.o
>
> Should I move to code to a new drivers/scsi/scsi_sense.c and add it to
> drivers/scsi/Makefile as:
>
> obj-$(CONFIG_BLK_SCSI_REQUEST) += scsi_sense.o
>
> Every place I want to use the code is already covered by
> CONFIG_BLK_SCSI_REQUEST, so it seems like I just need to know where to
> put the .c file. :P

I think this is so much saner than a SCSI select or dependency, so I'll
have to disagree with Martin and Christoph. Just put it in drivers/scsi,
if it's the location they care about.

--
Jens Axboe

\
 
 \ /
  Last update: 2018-05-23 16:14    [W:0.150 / U:0.028 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site