Messages in this thread | | | Date | Wed, 23 May 2018 13:48:23 +0200 | From | Boris Brezillon <> | Subject | Re: [PATCH] mtd: cmdlinepart: Update comment for introduction of OFFSET_CONTINUOUS |
| |
On Tue, 22 May 2018 17:07:53 +0200 Geert Uytterhoeven <geert+renesas@glider.be> wrote:
> The comment about offset zero was not updated when changing behavior: > - Automatic offset calculation is indicated by OFFSET_CONTINUOUS, > - Zero really means offset zero. > > Fixes: b175d03dd2072836 ("[PATCH] mtd cmdlinepart: allow zero offset value") > Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Applied.
Thanks,
Boris
> --- > drivers/mtd/cmdlinepart.c | 5 ++++- > 1 file changed, 4 insertions(+), 1 deletion(-) > > diff --git a/drivers/mtd/cmdlinepart.c b/drivers/mtd/cmdlinepart.c > index fbd5affc0acfe3fe..3ea44cff9b759e3c 100644 > --- a/drivers/mtd/cmdlinepart.c > +++ b/drivers/mtd/cmdlinepart.c > @@ -190,7 +190,10 @@ static struct mtd_partition * newpart(char *s, > extra_mem = (unsigned char *)(parts + *num_parts); > } > > - /* enter this partition (offset will be calculated later if it is zero at this point) */ > + /* > + * enter this partition (offset will be calculated later if it is > + * OFFSET_CONTINUOUS at this point) > + */ > parts[this_part].size = size; > parts[this_part].offset = offset; > parts[this_part].mask_flags = mask_flags;
| |