lkml.org 
[lkml]   [2018]   [May]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    SubjectRe: [PATCH v11 00/27] ARM: davinci: convert to common clo ck framework​
    From
    Date
    Hi David,

    On Friday 18 May 2018 10:18 PM, David Lechner wrote:
    > This series converts mach-davinci to use the common clock framework.
    >
    > The series works like this, the first 3 patches fix some issues with the clock
    > drivers that have already been accepted into the mainline kernel.
    >
    > Then, starting with "ARM: davinci: pass clock as parameter to
    > davinci_timer_init()", we get the mach code ready for the switch by adding the
    > code needed for the new clock drivers and adding #ifndef CONFIG_COMMON_CLK
    > around the legacy clocks so that we can switch easily between the old and the
    > new.
    >
    > "ARM: davinci: switch to common clock framework" actually flips the switch
    > to start using the new clock drivers. Then the next 8 patches remove all
    > of the old clock code.
    >
    > The final four patches add device tree clock support to the one SoC that
    > supports it.
    >
    > This series has been tested on TI OMAP-L138 LCDK (both device tree and legacy
    > board file).

    If you do end up sending a v12, you can leave out the mach-davinci
    portions unless there are any changes you need to make. I will pick them
    up from this series once the driver dependencies are merged.

    I do hope the drivers/clk/* changes can be merged from v4.18.

    Thanks,
    Sekhar

    \
     
     \ /
      Last update: 2018-05-22 11:40    [W:5.212 / U:0.048 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site