Messages in this thread | | | Subject | Re: [PATCHv2] arm64: dts: stratix10: Add QSPI support for Stratix10 | From | Thor Thayer <> | Date | Tue, 15 May 2018 15:10:41 -0500 |
| |
On 05/15/2018 10:11 AM, Dinh Nguyen wrote: > > On 05/11/2018 11:10 AM, thor.thayer@linux.intel.com wrote: >> From: Thor Thayer <thor.thayer@linux.intel.com> >> >> Add qspi_clock >> The qspi_clk frequency is updated by U-Boot before starting Linux. >> Add QSPI interface node. >> Add QSPI flash memory child node. >> Setup the QSPI memory in 2 partitions. >> >> Signed-off-by: Thor Thayer <thor.thayer@linux.intel.com> >> --- >> v2 s/_/-/ in qspi-clk >> rename flash node. >> use partition child node notation<snip>>> + qspi: spi@ff8d2000 { >> + compatible = "cdns,qspi-nor"; >> + #address-cells = <1>; >> + #size-cells = <0>; >> + reg = <0xff8d2000 0x100>, >> + <0xff900000 0x100000>; >> + interrupts = <0 3 4>; >> + cdns,fifo-depth = <128>; >> + cdns,fifo-width = <4>; >> + cdns,trigger-address = <0x00000000>; >> + clocks = <&qspi_clk>; >> + bus-num = <1>; > > I don't you need "bus-num" anymore right? I don't see it getting used > anywhere in the driver. > > Dinh >
Yes, I missed that holdover. Thanks, I'll correct that.
| |