lkml.org 
[lkml]   [2018]   [May]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 4.16 40/72] mtd: rawnand: marvell: fix command xtype in BCH write hook
Date
4.16-stable review patch.  If anyone has any objections, please let me know.

------------------

From: Miquel Raynal <miquel.raynal@bootlin.com>

commit a2ee41fd953e7c3ff6c55a3038c80354d191a318 upstream.

One layout supported by the Marvell NAND controller supports NAND pages
of 2048 bytes, all handled in one single chunk when using BCH with a
strength of 4-bit per 512 bytes. In this case, instead of the generic
XTYPE_WRITE_DISPATCH/XTYPE_LAST_NAKED_RW couple, the controller expects
to receive XTYPE_MONOLITHIC_RW.

This fixes problems at boot like:

[ 1.315475] Scanning device for bad blocks
[ 3.203108] marvell-nfc f10d0000.flash: Timeout waiting for RB signal
[ 3.209564] nand_bbt: error while writing BBT block -110
[ 4.243106] marvell-nfc f10d0000.flash: Timeout waiting for RB signal
[ 5.283106] marvell-nfc f10d0000.flash: Timeout waiting for RB signal
[ 5.289562] nand_bbt: error -110 while marking block 2047 bad
[ 6.323106] marvell-nfc f10d0000.flash: Timeout waiting for RB signal
[ 6.329559] nand_bbt: error while writing BBT block -110
[ 7.363106] marvell-nfc f10d0000.flash: Timeout waiting for RB signal
[ 8.403105] marvell-nfc f10d0000.flash: Timeout waiting for RB signal
[ 8.409559] nand_bbt: error -110 while marking block 2046 bad
...

Fixes: 02f26ecf8c772 ("mtd: nand: add reworked Marvell NAND controller driver")
Cc: stable@vger.kernel.org
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Tested-by: Chris Packham <chris.packham@alliedtelesis.co.nz>
Signed-off-by: Boris Brezillon <boris.brezillon@bootlin.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

---
drivers/mtd/nand/marvell_nand.c | 8 +++++++-
1 file changed, 7 insertions(+), 1 deletion(-)

--- a/drivers/mtd/nand/marvell_nand.c
+++ b/drivers/mtd/nand/marvell_nand.c
@@ -1404,6 +1404,7 @@ marvell_nfc_hw_ecc_bch_write_chunk(struc
struct marvell_nand_chip *marvell_nand = to_marvell_nand(chip);
struct marvell_nfc *nfc = to_marvell_nfc(chip->controller);
const struct marvell_hw_ecc_layout *lt = to_marvell_nand(chip)->layout;
+ u32 xtype;
int ret;
struct marvell_nfc_op nfc_op = {
.ndcb[0] = NDCB0_CMD_TYPE(TYPE_WRITE) | NDCB0_LEN_OVRD,
@@ -1419,7 +1420,12 @@ marvell_nfc_hw_ecc_bch_write_chunk(struc
* last naked write.
*/
if (chunk == 0) {
- nfc_op.ndcb[0] |= NDCB0_CMD_XTYPE(XTYPE_WRITE_DISPATCH) |
+ if (lt->nchunks == 1)
+ xtype = XTYPE_MONOLITHIC_RW;
+ else
+ xtype = XTYPE_WRITE_DISPATCH;
+
+ nfc_op.ndcb[0] |= NDCB0_CMD_XTYPE(xtype) |
NDCB0_ADDR_CYC(marvell_nand->addr_cyc) |
NDCB0_CMD1(NAND_CMD_SEQIN);
nfc_op.ndcb[1] |= NDCB1_ADDRS_PAGE(page);

\
 
 \ /
  Last update: 2018-05-14 09:02    [W:0.388 / U:0.100 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site