lkml.org 
[lkml]   [2018]   [May]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: Another NVMe failure, this time with AER info
On Sat, May 12, 2018 at 12:57 AM, Bjorn Helgaas <helgaas@kernel.org> wrote:
> Andrew wrote:
>> A friend of mine has a brand new LG laptop that has intermittent NVMe
>> failures. They mostly happen during a suspend/resume cycle
>> (apparently during suspend, not resume). Unlike the earlier
>> Dell/Samsung issue, the NVMe device isn't completely gone -- MMIO
>> reads fail, but PCI configuration space is apparently still there:
>
>> nvme nvme0: controller is down; will reset: CSTS=0xffffffff, PCI_STATUS=0x10
>
>> and it comes with a nice AER dump:
>
>> [12720.894411] pcieport 0000:00:1c.0: AER: Multiple Corrected error received: id=00e0
>> [12720.909747] pcieport 0000:00:1c.0: PCIe Bus Error: severity=Corrected, type=Physical Layer, id=00e0(Transmitter ID)
>> [12720.909751] pcieport 0000:00:1c.0: device [8086:9d14] error status/mask=00001001/00002000
>> [12720.909754] pcieport 0000:00:1c.0: [ 0] Receiver Error (First)
>> [12720.909756] pcieport 0000:00:1c.0: [12] Replay Timer Timeout
>
> I opened this bugzilla and attached the dmesg and lspci -vv output to
> it: https://bugzilla.kernel.org/show_bug.cgi?id=199695
>
> The root port at 00:1c.0 leads to the NVMe device at 01:00.0 (this is
> nvme0):
>
> 00:1c.0 PCI bridge: Intel Corporation Sunrise Point-LP PCI Express Root Port #5 (rev f1) (prog-if 00 [Normal decode])
> Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
> 01:00.0 Non-Volatile memory controller: Samsung Electronics Co Ltd NVMe SSD Controller SM961/PM961 (prog-if 02 [NVM Express])
> Subsystem: Samsung Electronics Co Ltd Device a801
>
> We reported several corrected errors before the nvme timeout:
>
> [12750.281158] nvme nvme0: controller is down; will reset: CSTS=0xffffffff, PCI_STATUS=0x10
> [12750.297594] nvme nvme0: I/O 455 QID 2 timeout, disable controller
> [12750.305196] nvme 0000:01:00.0: enabling device (0000 -> 0002)
> [12750.305465] nvme nvme0: Removing after probe failure status: -19
> [12750.313188] nvme nvme0: I/O 456 QID 2 timeout, disable controller
> [12750.329152] nvme nvme0: I/O 457 QID 2 timeout, disable controller
>
> The corrected errors are supposedly recovered in hardware without
> software intervention, and AER logs them for informational purposes.
>
> But it seems very likely that these corrected errors are related to
> the nvme timeout: the first corrected errors were logged at
> 12720.894411, nvme_io_timeout defaults to 30 seconds, and the nvme
> timeout was at 12750.281158.

The following patchset might help this issue:

https://marc.info/?l=linux-block&m=152604179903505&w=2

--
Ming Lei

\
 
 \ /
  Last update: 2018-05-12 04:39    [W:0.199 / U:0.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site