lkml.org 
[lkml]   [2018]   [Apr]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH 6/7] dt-bindings: gnss: add sirfstar binding
On Tue, Apr 24, 2018 at 11:34 AM, Johan Hovold <johan@kernel.org> wrote:
> Add binding for SiRFstar-based GNSS receivers.
>
> Note that while four compatible-strings are initially added representing
> devices which differ in which I/O interfaces they support, they
> otherwise essentially share the same feature set.
>
> Pin and supply names (and some recommended timings) vary slightly, but
> the binding recommends using a common set of names.
>
> Note that the wakeup gpio is not intended to be as a wakeup source, but
> rather to detect the current power state of the device (active or
> hibernate).
>
> Signed-off-by: Johan Hovold <johan@kernel.org>
> ---
> .../devicetree/bindings/gnss/sirfstar.txt | 38 +++++++++++++++++++
> .../devicetree/bindings/vendor-prefixes.txt | 3 ++
> 2 files changed, 41 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/gnss/sirfstar.txt

One nit below, otherwise:

Reviewed-by: Rob Herring <robh@kernel.org>

> diff --git a/Documentation/devicetree/bindings/gnss/sirfstar.txt b/Documentation/devicetree/bindings/gnss/sirfstar.txt
> new file mode 100644
> index 000000000000..5e6a02aec49a
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/gnss/sirfstar.txt
> @@ -0,0 +1,38 @@
> +SiRFstar-based GNSS Receiver DT binding
> +
> +SiRFstar chipsets are used in GNSS-receiver modules produced by several
> +vendors and can use UART, SPI or I2C interfaces.
> +
> +Please see Documentation/devicetree/bindings/gnss/gnss.txt for generic
> +properties.
> +
> +Required Properties:
> +
> +- compatible : Must be one of
> +
> + "fastrax,uc430"
> + "linx,r4"
> + "wi2wi,w2sg0008i"
> + "wi2wi,w2sg0084i"
> +
> +- vcc-supply : Main voltage regulator (3V3_IN, VDD, VCC)
> +
> +Optional Properties:
> +
> +- enable-gpios : GPIO used to power on and off device (ON_OFF)
> +- wakeup-gpios : GPIO used to determine device power state (WAKEUP, RFPWRUP)
> +- timepulse-gpios : Timepulse (e.g 1PPS) GPIO (1PPS, TM)
> +
> +Example:
> +
> +serial@1234 {
> + compatible = "ns16550a";
> +
> + gnss {
> + compatible = "wi2wi,w2sg0084i";
> +
> + vcc-supply = <&gnss_reg>;
> + enable-gpios = <&gpio0 16 GPIO_ACTIVE_HIGH>;
> + wakeup-gpios = <&gpio0 17 GPIO_ACTIVE_HIGH>;
> + };
> +};
> diff --git a/Documentation/devicetree/bindings/vendor-prefixes.txt b/Documentation/devicetree/bindings/vendor-prefixes.txt
> index 2128dfdf73f1..ddd81c82082d 100644
> --- a/Documentation/devicetree/bindings/vendor-prefixes.txt
> +++ b/Documentation/devicetree/bindings/vendor-prefixes.txt
> @@ -120,6 +120,7 @@ excito Excito
> ezchip EZchip Semiconductor
> fairphone Fairphone B.V.
> faraday Faraday Technology Corporation
> +fastrax Fastrax Oy
> fcs Fairchild Semiconductor
> firefly Firefly
> focaltech FocalTech Systems Co.,Ltd
> @@ -197,6 +198,7 @@ licheepi Lichee Pi
> linaro Linaro Limited
> linksys Belkin International, Inc. (Linksys)
> linux Linux-specific binding
> +linx Linx Technologies
> lltc Linear Technology Corporation
> lsi LSI Corp. (LSI Logic)
> lwn Liebherr-Werk Nenzing GmbH
> @@ -390,6 +392,7 @@ vivante Vivante Corporation
> vocore VoCore Studio
> voipac Voipac Technologies s.r.o.
> vot Vision Optical Technology Co., Ltd.
> +wi2wi Wi2Wi

Wrong spot.

> wd Western Digital Corp.
> wetek WeTek Electronics, limited.
> wexler Wexler
> --
> 2.17.0
>

\
 
 \ /
  Last update: 2018-04-25 20:26    [W:0.322 / U:0.524 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site