lkml.org 
[lkml]   [2018]   [Feb]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/6] dt-bindings: mfd: Add ST Multi-Function eXpander driver
Date
This patch adds documentation of device tree bindings for the
STMicroelectronics Multi-Function eXpander (MFX).

Signed-off-by: Amelie Delaunay <amelie.delaunay@st.com>
---
Documentation/devicetree/bindings/mfd/st-mfx.txt | 51 ++++++++++++++++++++++++
1 file changed, 51 insertions(+)
create mode 100644 Documentation/devicetree/bindings/mfd/st-mfx.txt

diff --git a/Documentation/devicetree/bindings/mfd/st-mfx.txt b/Documentation/devicetree/bindings/mfd/st-mfx.txt
new file mode 100644
index 0000000..423d800
--- /dev/null
+++ b/Documentation/devicetree/bindings/mfd/st-mfx.txt
@@ -0,0 +1,51 @@
+STMicroelectronics Multi-Function eXpander
+
+ST Multi-Function eXpander (MFX) is a slave controller using I2C for
+communication with the main MCU. Its main features are gpio expansion, main
+MCU IDD measurement (IDD is the amount of current that flows through VDD)
+and resistive touchscreen controller.
+
+Required properties:
+- compatible: must be "st,mfx"
+- reg: I2C address of the device
+- interrupts: interrupt triggered by MFX_IRQ_OUT signal
+- interrupt-parent: interrupt controller MFX is connected to
+- interrupt-controller: marks the device as an interrupt controller
+- #interrupt-cells: should be <1>, index of the interrupt within the
+ controller, in accordance with the "one cell" variant of
+ <devicetree/bindings/interrupt-controller/interrupt.txt>
+
+Optional nodes:
+
+* GPIO eXpander
+MFX provides 16 programmable GPIOs, and it is also possible to recover 8
+alternate GPIOs if the main functions are not used (touchscreen controller and
+IDD measurement not enabled).
+
+Required properties:
+- compatible : must be "st,mfx-gpio"
+- interrupt-parent : must be <&mfx>
+- interrupts = must be <0>
+- gpio-controller: marks the device node as a GPIO controller
+- #gpio-cells: should be <2>, the first cell is the GPIO offset on this GPIO
+ controller, the second cell is the gpio flags in accordance with
+ <dt-bindings/gpio/st-mfx-gpio.h>.
+
+Example:
+
+ mfx: mfx@42 {
+ compatible = "st,mfx";
+ reg = <0x42>;
+ interrupts = <8 IRQ_TYPE_EDGE_RISING>;
+ interrupt-parent = <&gpioi>;
+ interrupt-controller;
+ #interrupt-cells = <1>;
+
+ mfxgpio: mfx_gpio {
+ compatible = "st,mfx-gpio";
+ interrupt-parent = <&mfx>;
+ interrupts = <0>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ };
+ };
--
2.7.4
\
 
 \ /
  Last update: 2018-02-08 15:30    [W:1.705 / U:0.152 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site