lkml.org 
[lkml]   [2018]   [Feb]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [RESEND][PATCH] video: fbdev: atmel_lcdfb: convert to use GPIO descriptors
On Mon, Feb 5, 2018 at 10:47 AM, Ludovic Desroches
<ludovic.desroches@microchip.com> wrote:
> Use GPIO descriptors instead of relying on the old method.

Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>

Though few nitpicks below.


> --- a/drivers/video/fbdev/atmel_lcdfb.c
> +++ b/drivers/video/fbdev/atmel_lcdfb.c
> @@ -18,6 +18,7 @@
> #include <linux/delay.h>
> #include <linux/backlight.h>
> #include <linux/gfp.h>

> +#include <linux/gpio/consumer.h>

I think you forgot to remove of_gpio.h.

> #include <linux/module.h>
> #include <linux/of.h>
> #include <linux/of_device.h>

> struct device_node *display_np;
> struct device_node *timings_np;
> struct display_timings *timings;
> - enum of_gpio_flags flags;
> struct atmel_lcdfb_power_ctrl_gpio *og;
> bool is_gpio_power = false;
> int ret = -ENOENT;
> - int i, gpio;
> + int i;
> + struct gpio_desc *gpiod;

I would rather preserve reversed tree style, i.e. put longer line upper.


> + for (i = 0; i < gpiod_count(dev, "atmel,power-control"); i++) {
> + gpiod = devm_gpiod_get_index_optional(dev,
> + "atmel,power-control", i, GPIOD_ASIS);
> + if (!gpiod)
> continue;

What about IS_ERR() case?

>
> og = devm_kzalloc(dev, sizeof(*og), GFP_KERNEL);
> if (!og)
> goto put_display_node;
>
> + og->gpiod = gpiod;
> is_gpio_power = true;
>
> + ret = gpiod_direction_output(gpiod, gpiod_is_active_low(gpiod));
> if (ret) {

I'm not sure this will be needed if you check IS_ERR() above.

> + dev_err(dev, "set direction output gpio atmel,power-control[%d] failed\n", i);
> goto put_display_node;
> }


--
With Best Regards,
Andy Shevchenko

\
 
 \ /
  Last update: 2018-02-05 14:07    [W:0.193 / U:0.428 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site